coldline CPT-92 Kullanıcı Kılavuzu - Sayfa 3

Buzdolabı coldline CPT-92 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. coldline CPT-92 9 sayfaları. Commercial refrigerator and freezer

Sayfayı Yazdır

ELECTRICAL

Please ensure that the required voltage of the compressor is being supplied at

all times. Low or high voltage can detrimentally affect the refrigeration unit

All units should be plugged into a grounded and properly-sized electrical outlet

with

appropriate

overcurrent

protection.

Please

refer

the

electrical

requirements on the nameplate of the unit. Please make sure that your unit has

its own dedicated outlet. Do not use an extension cord.

TEMPERATURE CONTROLS

The temperature controls are factory-set to maintain an average temperature of

38 F in refrigerators and 0 F in freezers. To maintain a different temperature,

simply adjust the control knob located inside the unit.

To decrease the temperature (colder), turn clockwise. To increase the

temperature (warmer), turn counter-clockwise

CAUTlON

Setting the temperature control to the coldest setting may cause the evaporator

coil to freeze and ice up. This will eventually result in a warmer cabinet

temperature.

LOADING PRODUCT

Shelves have been factory-installed for your convenience. Before loading

shelves, please be sure that all shelf clips are completely fastened in their

correct locations. It is important that all shelves rest completely level before

stocking your cabinet with product.

In order to maintain correct air flow inside the unit, please be sure to leave two

to four (2 to 4) inches of space between the back wall and stored product.

Blocking the evaporator fans will result in a warmer cabinet temperature, and

ultimately compressor failure.

DEFROST SYSTEMS

Refrigerator coils are kept below the freezing point (32 F). During compressor

down-time, the evaporator fan continues to circulate air through the evaporator

coil. This air circulation raises the coil temperature above the freezing point,

melting any accumulated frost. Run-off water is drained into the evaporator pan

and evaporated. Freezer coils are defrosted electrically. Automatic defrost

timers are built-in to the refrigeration system and may not be adjusted. The

defrost timers automatically initiate at pre-set intervals and for a pre-determined

duration.

USRESTAURANT® RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE