Air Hogs F-14 Tomcat Kullanım Kılavuzu - Sayfa 4

Oyuncak Air Hogs F-14 Tomcat için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Air Hogs F-14 Tomcat 8 sayfaları. Replica series

Sayfayı Yazdır

1. Remove the broken

propeller as shown

in photo.

2. Check the direction

of the propeller

before attaching a

new one.

PROBLEM

Green charge light is not on.

1. Charge Nozzle is not installed all the way.

Engines will not start.

1. Jet is not fully charged.

2. Electric motor safety protection.

3. Electric battery safety protection.

No Control.

1. No batteries in controller/charger or low battery power.

2. Jet antenna is not fully extended all the way.

3. Flight controller antenna not fully extended.

4. It is a windy day.

Jet turns in the wrong

1. Jet is flying toward you and you have not

direction.

NOTE: If normal function of the product is disturbed or interrupted, strong electro-

magnetic interference may be causing the issue. To reset product, turn it com-

pletely off, then turn it back on. If normal operation does not resume, move the

• Requires 6 x 1.5-V AA alkaline batteries (not included).

• Batteries are small objects.

• Replacement of batteries must be done by adults.

• Follow the polarity (+/-) diagram in the battery compartment.

• Promptly remove dead batteries from the toy.

• Dispose of used batteries properly.

• Remove batteries for prolonged storage.

our F-14 Tomcat

is equipped with a Lithium Polymer battery.

SPECIAL LiPO BATTERY INSTRUCTIONS:

• Never charge battery unattended.

• Charge battery in isolated area. Keep away from flammable materials.

• Do not expose to direct sunlight.

• There is a risk of the batteries exploding, overheating, or igniting.

Do not disassemble, modify heat, or short circuit the batteries.

Do not place them in fires or leave them in hot places.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including

This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, in-

interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

cluding interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed

protection against harmful interference to radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that interference will not occur. if not installed and used in

to provide reasonable protection against harmful interference to radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that interference will not

accordance with the instructions, may cause harmful interference to radio communications. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the

occur. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this toy does cause interference to radio or television reception (you can check this by turn-

interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio

ing the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the

technician for help. NOTE:Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15

TV • Consult the dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semicon-

and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.

ductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.

PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly and battery removal must be performed by an adult. Do not use any tools for disassembly. Pulling, tearing, and deform-

ing of the product during disassembly, while necessary, should be as limited as possible. Do not compress the product at any time. Ensure product is turned off. Find a point where the two body halves meet; the nose of the aircraft or

where the wing meets the body. Start to peel the halves apart, separating them where they are glued together; remove any tape as necessary. Separate product body halves to expose internal electronics. To separate battery from

product use scissors to cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated. Dispose of battery in accordance with your local battery recycling or disposal

laws. NOTE: Opening of product and/or removal of battery will render product inoperative and voids manufacturer warranties, dispose of remaining product components in accordance with local laws.

CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.

RSS-310 Statement: This Category II radio communication device complies with Industry Canada Standard RSS-310.

Carrier frequency: 27.145MHz Field strength: 78.0dBuV/m at 3m.

Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly.

• If at any time in the future you should need to dispose of this product please note

that Waste Electrical Products should NOT be disposed of with household waste.

Please recycle where facilities exist. Check with your Local Authority or retailer for

recycling advice. (Waste Electrical and Electronic Equipment Directive).

Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada

Customer Care: 1-800-622-8339 Fax: 416-364-8005 Web: www.spinmaster.com

Email: [email protected]

Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,

NY 14221, USA

Spin Master Toys Far East Limited, Rm #1113, 11/F, Chinachem Golden Plaza,

77 Mody Rd., Tsimshatsui E., Kowloon, HK

Spin Master Toys UK Ltd., Riverhead House, Boston Drive, Bourne End,

Buckinghamshire, SL8 5YS, United Kingdom Customer Service: 01628 535 000

Email: [email protected]

Spin Master France – 59-60 Quai Le Gallo – 92100 Boulogne Billancourt – France

Service Après-Vente – Numéro vert : 0800 803 355 ou

E-mail : [email protected] – Site internet : www.spinmaster.fr

REPLACING THE PROPELLERS

Side

without

groove

Side with

groove

TROUBLESHOOTING GUIDE

CAUSE

reversed the way you use the throttle.

IMPORTANT BATTERY INFORMATION

Side with groove facing

outward.

the motor.

right

groove

left

1. Insert the Charge Nozzle all the way into the Charge port.

1. Charge the jet following "CHARGING YOUR JET" instructions.

2. Turn jet OFF and back ON to reset.

3. If jet was left on for more than 15 minutes and not used, it

automatically shuts off. To reset, turn jet OFF then ON again.

1. Replace the batteries in the controller/charger following the "BATTERY

INSTALLATION" instructions.

2. Gently uncoil the jet's antenna all the way.

3. Extend the silver flight controller antenna all the way.

4. Do not fly on windy days. Wind may overpower your plane's engines

and you will be unable to control the plane.

1. See the control reversal instruction section page 3.

product to another location and try again.

To ensure normal performance, change the batteries, as low batteries may not

allow full function.

• DO NOT incinerate used batteries.

• DO NOT dispose of batteries in fire, as batteries may explode or leak.

• DO NOT mix old and new batteries or types of batteries

(i.e. alkaline/standard).

• DO NOT use rechargeable batteries.

• DO NOT recharge non-rechargeable batteries.

• DO NOT short-circuit the supply terminals.

• Do not drop or subject to strong impacts.

• Do not allow the batteries to get wet.

• Only charge the batteries with the specified Spin Master™ battery charger.

• Only use the batteries in the device specified by Spin Master™.

• Carefully read the instruction guide, and use the batteries correctly.

• In the unlikely event of leakage or explosion use sand or a chemical fire

extinguisher for the battery.

• Batteries must be recycled or disposed of properly.

Air Hogs

F-14 Tomcat

is a registered trademark of Northrop Grumman Corporation and is

used under license to Spin Master Ltd. Manufactured for and distributed by Spin

Master Ltd. This product conforms to safety requirements of ASTM F963, EN71

& CHPA. • Please retain this information for future reference. • Please remove all

packaging materials before giving to children. • An adult should periodically check

this toy to ensure no damage or hazards exist, if so, remove from use. • Children

should be supervised during play. • Keep addresses and phone numbers for future

reference. • The item inside this package may vary from the photographs and/or

illustrations. MADE IN CHINA.

20017492

GTL English

REV 0

T44354_0001_20017492_GTL_IS_R1

Sharp point on the

right

motor shaft. The

propeller must be

replaced by an adult!

left

SOLUTION

Hereby, Spin Master Ltd., declares that this

F-14 Tomcat

is in compliance with the

essential requirements and other relevant

provisions of Directive 1999/5/EC.

<http://www.airhogs.com>

CAUTION:

Warning!

Choking Hazard –

Small Parts.