Canon EOS-1D Mark II Digial Kullanım Kılavuzu - Sayfa 14

Yazılım Canon EOS-1D Mark II Digial için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Canon EOS-1D Mark II Digial 41 sayfaları. Firmware update procedures
Ayrıca Canon EOS-1D Mark II Digial için: Broşür ve Teknik Özellikler (20 sayfalar), Kullanım Kılavuzu (28 sayfalar), Yazılım Kılavuzu (2 sayfalar), Yazılım Kılavuzu (2 sayfalar), Kullanım Kılavuzu (19 sayfalar), İpuçları ve Teknikler (35 sayfalar), Ürün Kılavuzu (39 sayfalar), Cep Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Teknik Özellikler (2 sayfalar), El Kitabı (29 sayfalar), Hızlı Kılavuz (2 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Güncelleme Kılavuzu (8 sayfalar)

Sayfayı Yazdır
Canon EOS-1D Mark II Digial Kullanım Kılavuzu

Adjusting with the Color Wheel

You can select a desired color from the color wheel.
You can also specify the hue in the range of 0 to 359 (in 1-stop increments), and the saturation
in the range of 0 to 255 (in 1-stop increments).
Click the [Tune] button.
1
The color wheel appears.
Adjust an image while viewing it.
2
Drag [
] to adjust an image.
Personal White Balance
You can apply the personal white balance (p.2-4) that you registered in the edit window or the
edit image window to images.
Makes white the standard for the point you selected and color in the image is adjusted.
1
2
You can enter a value or click the [ ] / [ ]
buttons to specify the hue and saturation.
Click the [1], [2] or [3] button.
The registered personal white
balance is applied to the image.
You cannot use the personal white balance if you have not registered it.

Click White Balance Function

Click the [Click (RAW)] button
When you move the cursor over the image, the cursor [ ] changes to [
Click the point where is to be the standard.
The color in the image is adjusted
with white as the standard on the
point you selected.
If you click on another point over
the image, the white balance is
adjusted again.
When you finish this operation,
click the [Click (RAW)] button.
The coordinates of the cursor position and the RGB values (8-bit conversion) of the
image are displayed in the lower left of the main window (p.1-2).
The image is adjusted based on the value of 1
Even if you have selected a neutral gray point of the image, the result of adjustments is
the same as when you select a white point.
.
(p.1-2)
].
1 pixels from the clicked point.
1-8
Cover/Table of
Contents
Introduction
Displaying Thumbnail Images
1
and Performing Basic Edits
in the Main Window
2
Performing Detailed
Edits in the Edit
Window
3
Performing Detailed
Edits in the Edit
Image Window
Displaying an
4
Image in the Quick
Check Window
5
Reference
Index