Daema DWF-7688KG Kullanıcı Kılavuzu - Sayfa 9

Yıkayıcı Daema DWF-7688KG için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Daema DWF-7688KG 10 sayfaları.

Sayfayı Yazdır

Use of detergent

Put the detergent powder into the

tub as the right figure.

Then colose the wash lid.

We suggest use low sudsing

detergent powder

How to use the washing powder

Dissolve in the machine directly（not suitable for delay program）

1. Low water level.

2. Add the washing powder, and run for 30 seconds to dissolve it completely.

3. Put laundries in, select suitable water level.

The instant dissolving of the washing powder

℃

1. Prepare warm water of 30

in a container.

2. Pour the powder while stirring to fully dissolve it.

The washing powder is more prone to pollute the laundries than the detergent,

therefore, please use it with proper quantity.

Washing powder with poor quality or not used for a long period may get blocked,

please clean the detergent box in time.

How to use bleach

Fill water to the selected level, dilute the bleach in the container,

and pour it slowly into the washing tub.

Do not use bleach for colored or figured laundries as they are prone

to lose colors.

Do not put bleach to laundries directly.

Refer to the manual for the usage and quantity of the bleach.

Please dissolve powder bleach before use.

For the quantity of the concentrated washing powder, please refer to its manual。

Remarks：avoid splashing of water and waste of washing powder, water level should not be too

high if laundries are too small.

Water inlet installation

Connect the inlet hose with the washing machine

1. Do not take off the water absorption cushion. Please

check if the cushion is dropped or damaged before

each usage. If it is, contact the seller immediately.

2. Put the inlet hose nut on the inlet valve connector.

3. Fasten the inlet hose nut and swing it gently to make

sue if it is suitable.

Inlet valve connector

Connect the inlet hose connector with the inlet hose

1. Push down the slider, insert the inlet hose into the connector

2. Hang the lock lever to the inlet hose connector and release

the slider till a click sound is heard. 。

Check the connection between inlet hose

connector and the tap

1. Swing the inlet hose gently to confirm if it is fastened.

2. After installation, open the tap and check if it leaks.

3. Do not bend the inlet hose with overstrain.

4. Before each usage, check the connection between

inlet hose connector and the tap, and the installation

of inlet hose. Make sure they are firmly fitted to prevent

dropping from improper installation position.

Dismantle the inlet hose

1. Close the tap.

2. Press the locking lever, push down the slider, and pull of the

inlet hose. If the machine is used frequently, the connector

of the inlet hose can be kept on the tap to prevent damaging

the fixing screw.

Inlet hose nut

Water absorption cushion

Inlet hose connector

Slider