Daema DFZ-620WB Kullanıcı Kılavuzu - Sayfa 5
Dondurucu Daema DFZ-620WB için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Daema DFZ-620WB 8 sayfaları.
Sayfayı YazdırUsage at the first time
Place the appliance according to the
installing requirements.
Open the door for air ventilating.
After installing the appliance, wait for 30 minutes at least before switching on the appliance.
( During transportation the oil in the compressor may have flowed into the refrigeration system.)
At the beginning, the cabinet is hot and the compressor will work for a long time and then stopped
by the thermostat at the set temperature. At that time, the compressor can works and stops regularly.
Recommend to put goods into the cabinet when the cabinet temperature reaches the set
temperature.
Thermostat
The freezer has double functions of cold storage and freezing, and the temperature can be adjusted
by the temperature control knob of the control panel.
When the temperature control knob is within the range of "refrigerate", the freezer is cold storage
℃
function, and the temperature range is - 2
range of "freeze", the freezer is a freezing function, and the temperature range is-12 ~-26 .
Turning clockwise, the stronger the cooling degree, the longer the continuous operation time of the
compressor; otherwise, turning counterclockwise, the weaker the cooling degree, the shorter the
continuous operation time of the compressor.
When the temperature control knob is within the range of "fast freeze", the freezer is the strong
cooling function.
℃
The temperature will be kept below - 20 , and the compressor will be forced to operate continuously.
Under normal use, it is not necessary to adjust this section to achieve energy-saving effect. If you
want to use this function, please do not exceed 2 hours. After use, you must remove it to avoid
compressor damage caused by long-term operation.
Please adjust the temperature control knob according to the local climate requirements to achieve
the power saving effect and extend the service life of the compressor.
Clean the inner cabinet before using.
℃
~ + 12 .When the temperature control knob is in the
℃
7 7
General knowledge for usage
Keep some spaces between stored goods.
It do good for cooling air circulating and
heat exchange and a better cooling effect
will be achieved.
For hot food, hold it cooled and then put
into the appliance. If put it in hot status, it
will decrease the cooling level of the
goods nearby.
℃
Put labels marked time onto the goods.
The goods stored early should be taken
out early.
When switching off or a power cut, must
restart after 5 minutes minimum.
Or it will shorten the compressor life or
even damage the compressor.
Seal the food by fresh kept bags or closed
container to avoid smell-mixed or dry.
Open the door as briefly as possible.
Make sure the door closed wholly to save
power consumption.
Set different cooling temperatures according
to different goods. Too low cooling
temperature will waste power consumption.
If know a power cut in advance, set the
thermostat for a low temperature and keep the
appliance cooling for some time. And open the
door as briefly as possible. When power is cut,
try not to open the door and do not add goods
into the appliance.
8