Dorex DX2 FC Kurulum Talimatları Kılavuzu - Sayfa 12
Kapı açma sistemi Dorex DX2 FC için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Dorex DX2 FC 12 sayfaları.
Sayfayı YazdırDOGGING (PANIC EXIT DEVICES ONLY)
DOGGING ACTIVATION
Cylinder Key
Depress push bar and turn flat/hex key or
cylinder key one full turn for dogging check.
CUT DEVICE (IF REQUIRED)
Recommended minimum clearance between
door frame stop and device end (with cap
removed) is 1³⁄16"
Face of door stop
Hinge
Side
DOOR
1³⁄16"
Minimum
Flat Tool/ or Hex Key
Center case aligned
with mounting holes.
CYLINDER DOGGING INSTALLATION
If cylinder is not installed, remove cover plate and install
cylinder with cam orientation as shown below.
Cam
Hinge
Side
BOTTOM VIEW
Install cylinder to the cover plate with
the cam facing towards the hinges.
For Alarm (AL) or Latch Monitoring (LM) panel installations,
follow the instructions supplied with those porducts.
Remove
Anti-Rattle Clip
Tape
1. With anti-rattle clip removed, tape and mark area being cut.
2. Cut off device and deburr.
NOTE:
Device rail cut must be square, smooth and clean for proper
fit with end cap
12 / 12
Cylinder
Cover Plate
Cylinder
Locating
whasher
Cylinder
Lock Nut
Slide cover in
to position on
the rail.
Cut off line
Cover Plate
(Flush to Push bar)
End Cap
WD-OD002 (666)
DX2PC-FC-INST
2021-10