Canon LV-7220 İşlevsel Özellikler - Sayfa 19
Projektör Canon LV-7220 için çevrimiçi göz atın veya pdf İşlevsel Özellikler indirin. Canon LV-7220 42 sayfaları. Expand serial functional specification
Ayrıca Canon LV-7220 için: İşlevsel Özellikler (20 sayfalar)
Sayfayı Yazdır
Expand Serial Command Functional Specification
8.6.3. CF_AVHPOS Command
Command
"CF_AVHPOS_%1" [CR]
"UP" ------------ Current setting value +1
%1
"DN" ------------ Current setting value –1
Set AV Service Mode Horizontal Position value.
(Only valid when it is in the usual Power On status)
Details
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.6.4. CF_AVVPOS Command
Command
"CF_AVVPOS_%1" [CR]
"UP" ------------ Current setting value +1
%1
"DN" ------------ Current setting value –1
Set AV Service Mode Vertical Position value.
(Only valid when it is in the usual Power On status)
Details
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.6.5. CF_AVSERV Command
Command
"CF_AVSERV_%1" [CR]
%1
"RST"
Set AV Horizontal / Vertical resolution that is set in such as "CF_AＶDDOTS"
/ "CF_AＶＤＬＩＮＥ" to default setting value.
Details
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.7. Input Control Command
8.7.1. CF_INPUT Command
Command
"CF_INPUT_%1" [CR]
"COMPUTER1" --------- Select Computer 1 Input
%1
"COMPUTER2" --------- Select Computer 2 Input
"VIDEO" ------------------- Select Video Input
Select Input. (Only valid when it is in the usual Power On status)
The Command works as the same as the Projector or Remote Control unit
"INPUT" button.
Details
Note1) If trying to select COMPUTER-2 terminal when setting Computer-2 to
Note2) When option box is installed, the selection of Computer-1 is Memory Card
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] ---- Input is PC
"000" [CR]
"101" [CR] ---- Input is PC
"000" [CR]
"101" [CR] ---- Input is PC
Monitor Out, the Projector returns "101".
/ Wireless / Network.
"000" [CR]
"%%%" [CR]
Page 18 of 41