Canon LV-7225 - LCD Multimedia Projector XGA İşlevsel Özellikler - Sayfa 16
Projektör Canon LV-7225 - LCD Multimedia Projector XGA için çevrimiçi göz atın veya pdf İşlevsel Özellikler indirin. Canon LV-7225 - LCD Multimedia Projector XGA 42 sayfaları. Multimedia projectors
Ayrıca Canon LV-7225 - LCD Multimedia Projector XGA için: İşlevsel Özellikler (20 sayfalar), Teknik Özellikler (6 sayfalar)
Sayfayı Yazdır
Expand Serial Command Functional Specification
8.5. PC Control Command
8.5.1. CF_FSYNC Command
Command
"CF_FSYNC_%1" [CR]
"0000 – 0031" --------- Directly set Fine Sync setting value
%1
"UP" --------------------- Fine Sync setting value +1
"DN" --------------------- Fine Sync setting value -1
Set Fine Sync for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable
8.5.2. CF_TDOTS Command
Command
"CF_TDOTS_%1" [CR]
"nnnn – 9999" -------- Directly set Total Dots setting value
%1
"UP" --------------------- Total Dots setting value +1
"DN" --------------------- Total Dots setting value –1
Set Total Dots for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable
8.5.3. CF_CLAMP Command
Command
"CF_CLAMP_%1" [CR]
"0000 – 0127" --------- Directly set Clamp setting value
%1
"UP" --------------------- Clamp setting value +1
"DN" --------------------- Clamp setting value –1
Set Clamp PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable
8.5.4. CF_H-POS Command
Command
"CF_H-POS_%1" [CR]
"0000 – nnnn" ------------ Directly set Horizontal Position setting value
%1
"UP" ------------------------- Horizontal Position setting value +1
"DN" ------------------------- Horizontal Position setting value –1
Set Horizontal Position PC signal.
(When it is in usual Power On state, this is valid)
Details
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] ---- Input is Video
"nnnn" is minimum value. This is current Display Dots
value＋Horizontal position value
"000" [CR]
"101" [CR] ---- Input is Video
"000" [CR]
"101" [CR] ---- Input is Video
"nnnn" is maximum value. This is current Total Dots
value - Display Dots value.
"000" [CR]
"101" [CR] ---- Input is Video
Page 15 of 41