Canon LV-7565 Şartname - Sayfa 10

Projektör Canon LV-7565 için çevrimiçi göz atın veya pdf Şartname indirin. Canon LV-7565 47 sayfaları. Multimedia projectors
Ayrıca Canon LV-7565 için: Broşür ve Teknik Özellikler (6 sayfalar), Broşür (6 sayfalar), Teknik Özellikler (6 sayfalar)

Sayfayı Yazdır
Canon LV-7565 Şartname
Expand Serial Command Specification

5. Functional Execution Command Table

5.1 Image Series Command Table

Execute command
CF_BRIGHT_%1 [CR]
CF_CONT_%1 [CR]
CF_COLOR_%1 [CR]
CF_TINT_%1 [CR]
CF_SHARP_%1 [CR]
CF_GAMMA_%1 [CR]
CF_WBAL-R_%1 [CR]
CF_WBAL-G_%1 [CR]
CF_WBAL-B_%1 [CR]
CF_COLTEMP_%1 [CR]
CF_NZRED_%1 [CR]
CF_PROGV_%1 [CR]
CF_IMAGE_%1 [CR]
CF_IMAGEADJ_%1 [CR]
CF_APCTRL_%1 [CR]
CF_COLMNSAV_%1 [CR]
CF_COLMNLD_%1 [CR]
CF_TURBO_%1 [CR]

5.2. PC Control Command Table

Execute command
CF_FSYNC_%1 [CR]
CF_TDOTS_%1 [CR]
CF_CLAMP_%1 [CR]
CF_H-POS_%1 [CR]
CF_V-POS_%1 [CR]
CF_DDOTS_%1 [CR]
CF_DLINE_%1 [CR]
CF SETPCADJ [CR]
CF_ORGMODE_%1 [CR]
CF_PCSTORE_%1 [CR]

5.3. Input Control Command Table

Execute command
CF_INPUT_%1 [CR]
CF_SOURCE_%1 [CR]
CF_INPUT1_%1 [CR]
CF_INPUT2_%1 [CR]
CF_INPUT3_%1 [CR]
CF_INPUT4_%1 [CR]
CF_SYSTEM_%1 [CR]
Item
Set Brightness value
Set Contrast value
Set Color value
Set Tint value
Set Sharpness value
Set Gamma value
Set White Balance Red vakue
Set White Balance Green value
Set White Balance Blue value
Set Color Temp. value
Set or cancel for Noise Reduction
Set or cancel for Progressive
Set Image mode
Reset or store for Image adjustment
Set Auto Picture Control
Store current color management setting status
Call color management setting status
Control Turbo Bright
Item
Set Fine Sync. value
Set Total Dots value
Set Clamp value
Set Horizontal Position value
Set Vertical Position value
Set Display Dots value
Set Display Line value
Reflect the setting value on the image
Specify serial for PC mode
Store current PC Adj. status to Mode 1, 2, 3, 4, or 5.
Item
Select Input
Select Input source
Select Input-1 and also set source to %1 at once
Select Input-2 and also set source to %1 at once
Select Input-3 and also set source to %1 at once
Select Input-4 and also set network
Select System
Page 9 of 46