Dorma CL700 Kurulum Talimatları
Kilitler Dorma CL700 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Dorma CL700 2 sayfaları. Cylindrical leverset
Sayfayı Yazdır
CL700 CYLINDRICAL LEVERSET
—
Installation Instructions
2. Install lock assembly
Adjust for door thickness
2.2 Slightly separate the thru-bolt
-¾ "
NOTE: Lock comes adjusted for 1
retainer from the outside rose.
door from the factory.
2.3 Rotate the outside rose assembly
2.1 To adjust the lock assembly for
to adjust for proper door thickness.
door thickness, align so the center
of the chassis is in line with the
2.4 Realign the thru-bolt retainer with
center of the latch.
the outside rose.
Center of
latch
Thru-bolt
retainer
Outside rose
Chassis
assembly
2
www.dorma.com
Overall Exploded View
Tools required for installation
6
#2 Cross drive screwdriver
5
4
14
3
2
1
Install chassis
2.5 Slide the lock assembly into the face of the
door.
Be sure to engage the inner latch mechanism
of the chassis with the back of the latch as
of the chassis with the back of the latch as
shown.
shown.
Latch
8
7
10
9
Part List
1 - IC core
2 - Outside IC lever
3 - Conventional cylinder
4 - Inside conventional
cylinder lever
5 - Lock assembly
6 - Inside rose mounting plate
7 - 10-32 x 1-½ " screws (x2)
8 - Inside rose
9 - Lever insert
10 - Inside lever
11 - 8-32 x ¾ " combo screws (2)
11
12 - Latch
13 - Latch sleeve
14 - Outside rose assembly
12
13
3. Install inside rose mounting plate
3.1 Hold the lock
Be sure holes in
assembly in place.
plate are aligned
with the holes in
3.2 Thread the inside
the door.
rose mounting
plate onto the
3.3 Secure the
chassis until snug
mounting plate
against the door
using two
and tighten using
10-32 x 1-½ "
the included
screws.
spanner wrench.
Spanner
wrench
Chassis
Inside rose
mounting
plate
3
1. Install latch
1.1 Place the latch into the door edge.
Orient such that the beveled edge of the latch
faces the door jamb.
¾
" combo screws.
1.2 Secure with two 8-32 x
NOTE: Latch sleeve to be used for doors with
1-1/8" face plate prep and 1" latch bore.
Beveled
edge
1
4. Install rose
4.1 Push the inside rose
onto the inside rose
mounting plate
oriented such that the
rose notch is
facing downward.
facing downward.
Inside
rose
Inside
lever
Inside
rose
Spindle
mounting
plate
NOTE: Be sure the lever
insert is inserted into
the inside lever prior to
installation.
4.2 Push the inside lever
onto the spindle until
Rose
it clicks into place.
notch
4
location
5. Install strike
5.1 Insert strike as shown, and secure with two
12-24 x 1" combo screws.
Strike part list
1 -
Strike plate
2 -
12-24 x 1" combo-screws
1
2
5
76002003 07/15