Canon WUX10 - REALiS WUXGA LCOS Projector Kullanıcı Kılavuzu - Sayfa 21
Projektör Canon WUX10 - REALiS WUXGA LCOS Projector için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Canon WUX10 - REALiS WUXGA LCOS Projector 25 sayfaları. Lv series lcd multimedia projectors and visualizer
Ayrıca Canon WUX10 - REALiS WUXGA LCOS Projector için: Broşür ve Teknik Özellikler (12 sayfalar), Ürün Kılavuzu (18 sayfalar), Ürün Kılavuzu (10 sayfalar)
Sayfayı Yazdır
2.5.7
Setting the Protocol of a Projector
Projectors in the Projector list will display as "Disconnected" if network settings of projectors
are changed. In this case, adjust the protocol settings of the projector labelled "disconnected"
in accordance with the changed network settings, with the following procedures.
1
Select [Protocol settings] from the [Projector] menu.
"Protocol settings" dialog will appear.
2
Select a protocol from the [Protocol] pop-up menu, and adjust the settings.
Category
IP address
Community name
(SNMP V1/V2c/V3 only)
Port number
(LV Series only)
Timeout
Password
(SNMP V3 only)
Note
-
An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
-
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
-
Projectors may not connect immediately after its IP address is changed.
Refresh the projector status after a while.
3
Click [OK] when you have finished adjusting the settings.
Projector's protocol settings will be changed.
Enter an IP address of the projector, in "XXX.XXX.XXX.
XXX" form.
E n t e r a c o m m u n i t y n a m e w i t h i n 1 5 o n e - b y t e
alphanumerical characters and symbols.
Enter a port number to be used, in one-byte numbers.
Default value is set to "7142".
Enter a number of seconds to time out, from 1 to 9.
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
* Password is reset if protocol is changed.
CHAPTER 2 • Routine Operation
Description
2C