Dorma ESA II Hızlı Başlangıç Kılavuzu

Kontrolör Dorma ESA II için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dorma ESA II 2 sayfaları.
Ayrıca Dorma ESA II için: Manuel (10 sayfalar)

Sayfayı Yazdır

DORMA

1 Door must be installed and adjusted completely. The door must slide without binding.

2 Door must be fully wired and safety devices must be normally closed

If using BEA Wizards change presence to NC output by changing the relay output from the default of 4 to 1 with

the remote.

If using the Reglomat Profusion change presence output to NC with remote by pressing E +2+2

If the door has Micro Cell holding beams wired to one presence input wire the Wizards as follows to the one open

presence input. Wire nut the blue from one Wizard to the brown of the other then wire the remaining blue and

brown to the presence input. (The Wizards have to be wired in series if connected to one input.)

The door will not tune in or function without a closed contacts or jumpers on the following terminals 21 (Dish)

and 23 (Arrow) Presence 2, 26 (Dish) and 28 (Arrow) Presence 1 and terminals 32 and 33 Breakout (Emergency

Stop)

3 With the power disconnected slide the door open half way. Place the jamb switch to the off or closed position, Exit

only off and Partial Open to off.

4 Plug the power in and observe the door after a few seconds the door should move in the closing direction if it

opens unplug the power and see step 5 if it closes move to step 6.

5 If at initial startup the door moved in the opening direction with the power disconnected slide the door open half

way then press and hold the Service button. While pressing the Service button connect the power plug. Hold the

button until you see and 8 appear in the display. The 8 will flash twice once the reset is complete.

If the door moves in the closing direction proceed to 6. If it moves in the opening direction press the minus (-)

button to change the motors direction.

6 After the door closes perform a learn cycle by pushing the Service button until the display starts to rotate. The

door accelerates to determine the door weight and then open the rest of the way in creep speed.

The 8 will blink twice then a dot will appear indicating that the learn cycle is complete and the door will close at

normal speed.

DORMA AUTOMATICS, Inc.

ESAII CONTROLER

Quick Start

Quick Start Guide ESAII

924 Sherwood Drive

Lake Bluff, IL 60044

E-mail: [email protected]

DL0000-000

Toll-Free: 877-367-6211

8/25/2009

Fax: 877-423-7999

Subject to change without notice

NC Safety Circuit

Presence output

NC input or Jumpers on

21 & 23, 26 & 28, and 32

& 33

Switch in Off position

for Tune in.

Door should close at start

Perform a learn cycle.

1 of 2