DORMA-Glas UNIQUIN Montaj Talimatı - Sayfa 2
İç Mekan Mobilyaları DORMA-Glas UNIQUIN için çevrimiçi göz atın veya pdf Montaj Talimatı indirin. DORMA-Glas UNIQUIN 20 sayfaları.
Sayfayı YazdırDORMA-Glas
1
About this manual
1.1
Information about the manual
This manual describes how to install a UNIQUIN mounting
profile as part of a UNIQUIN partition wall system and provides
maintenance and care information.
Further unit components and mounting instructions may be
required to complete the UNIQUIN partition wall unit's mounting
according to the project-related unit drawing, e.g. for the
door frame unit with hinges and overpanel. The illustrated unit
components and configurations are exemplary and do not show
every possible mounting situation.
1.2
Other applicable documents
Refer to the following technical documents for the product:
• The project-related unit drawing
• The mounting instructions of all unit components
• The UNIQUIN system manual
1.3
Target group
The target group of these mounting instructions is qualified
personnel who have been specially trained in glazing installation.
1.4
Symbols used
1.4.1
Safety instructions
Safety instructions are marked with symbols. The safety
instructions are introduced by signal words that express the extent
of the hazard, e.g.:
WARNING
This signal word indicates a situation of potential
risk, which could lead to death or serious injury if not
averted.
CAUTION
This signal word indicates a situation of potential risk,
which could lead to minor or slight injury if not averted.
ATTENTION
This signal word indicates a situation of potential
risk that could lead to damage to property or the
environment if not averted.
NOTE
This signal word indicates useful information for
efficient and trouble-free operation.
2
UNIQUIN Mounting profile
WN 059546 45532
1.4.2
Further labeling
1.
2.
Step-by-step graphics
Position numbers for parts
1
2
in diagrams
2
Safety
2.1
Intended use
The product is designed to connect a UNIQUIN partition wall
system to the floor, wall and ceiling from the inside.
The product may only be mounted with unit components designed
by dormakaba for the installation situation and approved according
to the project-related unit drawing.
• The product may only be mounted undamaged and in accordance
with the requirements of the assembly location.
• The product may only be mounted by qualified personnel who
correspond to the defined target group.
• Only toughened safety glass (TSG) or laminated safety glass
(LSG) made of TSG may be installed with the product.
• The use of other composites must be checked by the designer or
contractor and the stability assured.
• The product may only be attached to a surface capable of bearing
loads using suitable fixing materials.
• The product is only suitable for indoor use.
• The product is suitable for use in tropical countries.
About this manual
2023-08 / 16676