Cansec MAP1 Konfigürasyon - Sayfa 9
IP Erişim Denetleyicileri Cansec MAP1 için çevrimiçi göz atın veya pdf Konfigürasyon indirin. Cansec MAP1 12 sayfaları.
Sayfayı YazdırKey Section & Name
[USBCFG]
Password
IP
Netmask
Gateway
SrvPort
DiagPort
UpdatePort
Encryption
Authenticate
IpSecurity
ClientIp
HostName
HostRetryInterval
Value
[USBCFG]
Cansec
10.0.0.101
255.255.255.0
10.0.0.1
5000
5001
5002
0
0
0
0.0.0.0
cloudacs.com
60
MAP1 IP Configuration
Description
DO NOT
Key section –
Factory default password. Please
modify to an appropriate password of
your choice other than the default
password.
Factory default IP address. Please
obtain a static IP address from IT
personnel and fill it here.
Factory default subnet mask. Please
specify the subnet mask where the
host computer is connected to.
Factory default gateway. Please
specify the gateway where the host
computer is connected to.
Factory default server port. You may
change it or leave it as default.
Factory default diagnostic port. You
may change it or leave it as default.
Factory default update port. You may
change it or leave it as default.
For future use only.
For future use only.
Specify if trusted host is enabled or
disabled. 1=enabled, 0=disabled
The IP address of the host computer
First Access Express
having the
software installed. If IpSecurity is
enabled and ClientIp has a valid IP
address specified then the MAP1
controller accepts data connection
(SrvPort 5000) from only this host
computer. Other connections on
DiagPort 5001 and UpdatePort
5002 are not affected by this setting.
Applicable for Cloud based controller.
The default hostname is cloudacs.com
The default retry interval in seconds
July 2021 • Rev. 1.2
change
Page 9 of 12