Cansec Zodiac FR100 Kurulum Kılavuzu - Sayfa 10
IP Erişim Denetleyicileri Cansec Zodiac FR100 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cansec Zodiac FR100 15 sayfaları.
Sayfayı Yazdır
READER MOUNTING
RJ-45 Jack
Tamper Switch
Terminal Blocks
NOTE: For standalone application either use plug-in transformer OR terminal block for
power input.
1. Do not install the mounting plate to the reader until the last step.
2. Connect cables with terminal blocks through the gap of the mounting
See Wiegand reader wiring section
plate as shown.
3. If necessary, connect an Ethernet cable (RJ-45) to the RJ-45 jack through
the gap of the mounting plate.
4. If mounted as a standalone reader, use the supplied transformer and plug
the connector to the 12VDC port through the gap of the mounting plate.
5. Install the mounting plate to the wall (1.15 to 1.20 m above the ground).
See mounting plate section above for more information
6. Mount the reader to the mounting plate using the mounting holes and the
mounting studs and ensure it is rested steadily on the mounting plate.
7. Tighten screws at the bottom of the mounting plate to the reader.
12 VDC Input
TM
Zodiac FR100
Installation Manual
Mounting Hole
Mounting Studs
Anchor Holes
Screws
.
.
Page 10 of 15
June 2014 • Rev. 1.2