Cantaloupe Radio MDeck BA-2 Kullanıcı El Kitabı - Sayfa 5

Araba Stereo Sistemi Cantaloupe Radio MDeck BA-2 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Cantaloupe Radio MDeck BA-2 8 sayfaları. Bluetooth retrofit kit, compatible with cm5905/cm5907/cm5908

Sayfayı Yazdır

SOURCE SELECTION

Cycling through the 3 audio sources is done by the follow-

ing:

To switch from tuner to Bluetooth or Bluetooth to aux, push

and release the volume knob. To switch from aux back to

tuner, press the "1/EJ" button.

PLAY/PAUSE

To play or pause the streaming Bluetooth media, press the

"5/PROG" button in Bluetooth mode. The playback state is

indicated on the display. A "1" indicates content is playing

and a "2" means it is paused.

PREVIOUS/NEXT TRACK

To seek to the previous or next Bluetooth track, use the cor-

responding "SEEK" button while in Bluetooth mode.

REWIND/FAST-FORWARD

To rewind through Bluetooth content, press the "3/REW"

button. To fast-forward, press the "4/FF" button. To end ei-

ther of these actions, press the same button again, or press

the "5/PROG" button.

SIRI/GOOGLE VOICE ASSISTANT

Your phone's voice assistant can be invoked directly from

the radio by pressing the "1/EJ" button in Bluetooth mode.

After a short delay, your assistant's chime will play to indi-

cate it is now listening for your command. Say your com-

mand and your assistant will process your request like nor-

mal. To dismiss the assistant at any time, press the "1/EJ"

button again.

CALL HANDLING

When an incoming phone call is ringing, you can answer the

call by pressing the "5/PROG" button. To reject an incoming

call, press the "1/EJ" button. During a call, the call can be

ended by pressing the "5/PROG" button.

AUTOMATIC SOURCE SWITCH FOR CALLS

To ensure an incoming call is not missed, the radio will au-

tomatically switch to Bluetooth mode if a call comes in while

another source is selected.

DOLBY

NOISE REDUCTION

Note that Dolby Noise Reduction is still available in Blue-

tooth and aux mode. However, it should not be enabled as

this will cause decreased audio clarity. It is disabled by de-

fault, but if a

icon is shown on the display, press the

"2" button to disable it.