Cantium Scientific MicroBio MB2 Kullanım Kılavuzu - Sayfa 6
Laboratuvar Ekipmanları Cantium Scientific MicroBio MB2 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cantium Scientific MicroBio MB2 16 sayfaları.
Sayfayı Yazdır
MicroBio Operating Manual [P0001W006]
Inserting a Plate/Dish
For both MB1 and MB2 models, remove the sampling head cover carefully, unless it is being carried
separately in a sterile container. Only hold the edge of the head. Do not touch the front or rear
(inside) surface close to the holes. If necessary the head should be sterilised. Insert a contact plate
inside the springs so that its base sits firmly on the three support posts; then re-fit the sampling
head.
MB1
The MB1 is an extremely simple to use entry level sampler with basic features to get the job done
with the minimum of fuss.
Switching On and Off
To switch the unit on press any of the four switches. The display will show the last volume setting
used. The unit will switch itself off automatically if not used for 20 seconds.
Setting Sample Volume
To select a volume of air to be sampled use the
+
and - buttons to increase or decrease the amount.
The MB1 has fourteen pre-set volumes of: 25, 50, 100, 150, 200, 300, 400, 500, 600, 750, 800, 1,000,
1,200 and 1,500 litres.
Starting/Stopping Samples
Press the
START
button to start the sample process. When running, a red LED at the top end of the
sampler will illuminate. If at any point it is required to stop sampling early, press the
CANCEL
button.
The MB1 will stop sampling when the required volume of air has been sampled. The red light will
extinguish at the top of the unit.
June 2012
6 / 16