Advance acoustic AdVac 12HP Operatör El Kitabı - Sayfa 8

Elektrikli Süpürge Advance acoustic AdVac 12HP için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Advance acoustic AdVac 12HP 10 sayfaları.

Sayfayı Yazdır

INTRODUCTION

This manual will help you get the most from your Advance AdVac™.

Read it thoroughly before operating the machine.

This product is intended for commercial use only.

PARTS AND SERVICE

Repairs, when required, should be performed by your Authorized

Nilfisk-Advance Service Center, who employs factory trained service

personnel, and maintains an inventory of Nilfisk-Advance original

replacement parts and accessories.

Call the NILFISK-ADVANCE DEALER named below for repair parts

or service. Please specify the Model and Serial Number when

discussing your machine.

(Dealer, affix service sticker here.)

NAME PLATE

The Model Number and Serial Number of your machine are shown on

the Nameplate on the bottom of the machine. This information is

needed when ordering repair parts for the machine. Use the space

below to note the Model Number and Serial Number of your machine

for future reference.

MODEL NUMBER

SERIAL NUMBER

UNCRATE THE MACHINE

When the machine is delivered, carefully inspect the shipping carton

and the machine for damage. If damage is evident, save the shipping

carton so that it can be inspected. Contact the Nilfisk-Advance

Customer Service Department immediately to file a freight damage

claim.

MACHINE ASSEMBLY

CAUTION!

Fully assemble the cleaner before using.

A - ASSEMBLY PACKET

The packet contains two 2-part bolts and two cord hooks. An extra

drive belt is also included.

B – ATTACH LOWER / UPPER HANDLE

Slip the upper handle (D) and the lower handle (E) together so the

handle bolt holes align and the slots in the handle are positioned as

shown in Figure 4. Insert a 2-part bolt (A) in the center of the handle

and tighten. Hold the assembled handle (D/E) so it curves away from

the cleaner. Then push the handle into the handle socket (F) at the

rear of the cleaner. Align the holes, insert the other 2-part bolt (A), and

tighten.

8 - FORM NO. 56041522 - AdVac

™

11 / 12 / 12HP / 16HP

C / D – CORD HOOKS

UPPER CORD HOOK: Pull the spring (G) on the cord upward toward

the top of the handle. Insert the lower half of the spring (G) into the

upper cord hook (B).

Make sure slots in handle are positioned properly (Figure B). Place

inner tab into slot as shown in (1) and press hook around handle (2),

snapping opposite inner tab into place (3) (Figure D).

LOWER CORD HOOK: Insert the power cord into the lower cord

hook (C) (Figure C). Snap the hook into the lower handle. Pull the

cord up to tighten but leave enough slack near the base so the cord

is not strained when the handle is lowered. Wrap the cord around the

two cord hooks. Fasten the plug to the cord to prevent unwinding.

E - HOW TO INSTALL THE BAG

Insert the bag adapter clip (H) on the bottom of the bag collar into the

bag adapter retainer (I) below the air outlet. Push the bag collar up

and forward so the locator lug (J) to the right of the cam latch (L) slides

into the slot (K), then turn the cam latch to lock the bag onto the

shoulder rivet (M). To support the bag, loop the spring (N) from the

top of the bag onto the bag support, located to the back of theupper

cord hook (B) (Figure B).

OPERATION

F - POWER SWITCH

The power switch is located at the rear of machine, to the left of the

handle base. Simply step on it to turn the machine on or off.

G - HANDLE ADJUSTMENT

The handle lock is located at the left rear side of the machine. Simply

step on it to release and move the handle to one of the three positions.

H - HEIGHT ADJUSTMENT

This machine has a 6-position adjustment knob. To select the proper

setting, move the knob to the highest setting. Turn down one setting

at a time until the machine's sound changes to a smooth buzzing or

vibrating tone. This is the sound of the beater bars grooming the pile.

NOTE: Raise the front of the machine to ease changing the settings.

DUAL PURPOSE BAG

CAUTION!

Never wash or dry-clean cloth bag.

This machine comes with a cloth bag that can be used with or without

disposable paper bags. Before first use, decide which way the

machine is to be used.

NOTE: Once the cloth bag is used without a paper bag, do not use

it with a paper bag at any time.

I - CLOTH BAG USAGE

Unzip the cloth bag and pull the bag throat out of the bag's top fill

sleeve. Remove coil spring, and replace bag throat back into sleeve.

NOTE: Failure to remove spring will result in premature bag wear and

leakage.