Canyon 90-160 Montaj Talimatları - Sayfa 2
İç Mekan Mobilyaları Canyon 90-160 için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Canyon 90-160 5 sayfaları. Step bunk bed
Sayfayı Yazdır
CANYON FURNITURE COMPANY.
1.-PROCEED TO ASSEMBLE THIS STEP BUNK BED,FIRST CHOOSING THE CONFIGURATION THAT FITS YOUR ROOM,LEFT OR RIGHT SEE FIG.9,IF LEFT
GO TO STEP # 3 OR RIGHT GO TO STEP # 2.
2.- CHANGE SAFETY GRILL THAT IS FACTORY INSTALLED IN LEFT SIDE TO THE RIGHT SIDE,USING A PHILLIPS SCREWDRIVER (NOT INCLUDED) REMOVE
SCREWS FROM STEP (SAVE THE SCREWS TO RE-ATTACH THE GRILL TO RIGHT SIDE), THEN INSTALL GRILL THE RIGHT SIDE, SEE FIG.9
3.- TO ASSEMBLE STEP BUNK BED DO BACK PART FIRST USING ONE STEP BUNK BED HEADBOARD (E),ONE UPPER BED END (A),ONE 3 DRW STUDENT
DESK (C) OR 5 DRW STUDENT CHEST (D), ONE SIDE RAILS (F), ONE GUARD RAILS (G), FIRST INSERT ONE METAL DOWEL PIN (B) IN EACH OUTSIDE
CORNER OF DESK OR CHEST, TAKE THE UPPER BED END (A) AN PLACE IT ON TOP OF THE DESK OR CHEST, ALIGNING THE METAL DOWEL PIN (B)
WITH EACH PRE-DRILLED HOLE IN EVERY END OF THE UPPER BED UNTIL THE METAL DOWEL PIN (B) ARE ALL THE WAY IN THE HOLE OF THE UPPER
BED, SEE FIG.6.
4.- ATTACH SIDE RAILS (F) AND GUARD RAILS (G) TO THE STEP BUNK BED HEADBOARD (E) AND UPPER BED END (A),INSERTING TWO HEX BOLTS (I)
AND WASHERS (K) INTO THE BUNK BED HEADBOARD AND THE UPPER BED END HOLES, SEE FIG.7
5.- INSERT TWO CROSS DOWEL NUTS (J) IN ACCESS HOLE INSIDE SIDE RAILS (F) ALIGN THE CROSS DOWEL NUTS AS SHOW IN FIG.A, USE THE HEX
KEY (L) TO TIGHTEN BOTH HEX BOLTS UNTIL SECURE, REPEAT PROCESS WITH GUARD RAIL.
6.- REPEAT PROCESS WITH FRONT PART SEE FIG.8, ONLY TOP SIDE RAIL AND GUARD RAIL.
7.- PLACE 4 SLATS (H) ON TOP SIDE RAILS CLEATS (F), PLACE ONE SLAT IN BOTH HEADBOARD&FOOTBOARD ENDS, PUSH THE SLATS ( H) AGAINST
THE BED END POST (FIG.B) AND TWO AT EQUAL DISTANCE FROM THE END SLATS, SECURE WITH 1 1/4" SCREWS (M) ALL SLATS ENDS. (FIG.10)
ACCESS HOLES
FIG. 6
FIG. A
FIG. 7
FIG. 8
BACK PART
FRONT PART
FIG. B
FIG. 10
FIG. 9
REV 02 09/30/09
PAGE 2 OF 5
KIS00949