Advance Appliance SFUTS 300 Kurulum ve Kullanım Kılavuzu - Sayfa 5

Su Isıtıcı Advance Appliance SFUTS 300 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Advance Appliance SFUTS 300 12 sayfaları. Advance universal multi-fuel thermal store

Sayfayı Yazdır

SFUTS FULLY WIRED AND PLUMBED FOR SOLID FUEL

WITH GAS/OIL BOILER ETC

The SFUTS (Solid Fuel Universal Thermal Store) takes the worry out of installation. It offers a fully

integrated store with all relevant controls and safety features. It has three pumps fitted - a boiler

pump, a heating pump and a re-circulator for the solid fuel device to aid heat up and stratification

when the appliance is first lit. The sensor head can be adjusted, we recommend 50°C to 60°C.

The sensing probe must be left as supplied, strapped to the pipework.

A heat sink (towel radiator or similar) needs to fitted as shown in the schematic. Two dual

thermostats with over-heat protection are fitted (the third is for solar and is left to the installer)

and a thermal safety valve is fitted in sealed heating circuits, plumbed in with the pressure relief

valve to tun-dish discharge. This valve is thermo-mechanical and will work in the case of an

interruption to electrical supply.

A 3amp supply from a fused spur is recommended, and you will need to wire a programmer/

room thermostat to the fitted junction box. Means for disconnection of the supply must be

incorporated in the fixed wiring in accordance with the wiring rules. The mains supply wiring

must be fixed in a way that prevents it coming into contact with hot parts (those that can

experience a temperature rise of >50°C), or, that the insulation of the mains supply wiring must

be protected, for example, by insulating sleeving having an appropriate temperature rating.

A pipe thermostat is supplied loose (but electrically connected) to mount about a metre away

from the solid fuel appliance on the flow pipe. This thermostat senses when the appliance is

lit/turned on. Wiring instructions come with the unit. The wiring centre is labelled for 3amp

(50HZ) mains input, switched live boiler and programmer connections.

If the supply cord or any wiring on the store is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualified persons in order to avoid a hazard.

You will need to connect the boiler flow and return pipes, the solid fuel flow and return and the

heating flow and return. Pumps are fitted and pre wired. The solid fuel circuit contains an injector

tee, pump and blending valve to prevent cold water being returned to the wood burner.

The unit meets the requirements of G3.

SFUTS SCHEMATIC

Wood burner

Boiler flow

Heat Leak

owel Rail)

Piped for

gravity

Boiler return

Pipe

stat

Blending Valve

This schematic is for solid fuel pumped circulation.

Note: A heat sink must be fitted

Universal

Thermal store cylinder

(Boiler)

Pump 3

Dual stat 2

Injector Tee

Dual stat 1

Pump 2 (Solid Fuel)

Pump 1

Htg flow

Htg return