Daewoo electricals HEA1187 Manuel - Sayfa 6

Isıtıcı Daewoo electricals HEA1187 için çevrimiçi göz atın veya pdf Manuel indirin. Daewoo electricals HEA1187 8 sayfaları. Mini convector heater

5. Re-attach the heater to the wall bracket.

NB This Mini Convector Heater must not be permanently wired to the mains.

Operating Your Mini Convector Heater

1. Insert the mains plug into the nearest mains socket.

2. Press the On/Off switch at the bottom right hand side to the on position

by pressing 'I', the switch will illuminate to show the unit is powered up.

3. Rotate the Thermostat clockwise to increase the room temperature,

rotate anticlockwise to decrease the temperature.

4. The heat indicator lamp will go on and off during use to show that the set

temperature is being maintained – this is quite normal.

Frost Protection

This heater is fitted with an Anti-Frost device, this operates the heater

automatically when the room temperature drops below 10˚C.

Note: The Anti-frost function operates when the thermostat is set to the

lowest level.

Hint on setting the correct temperature

1. Set the heater to the desired heat setting as above.

2. Rotate the Thermostat to the maximum position and allow the room to

warm up. Once the desired room temperature has been reached turn

the Thermostat anticlockwise until the heater just clicks off then turn it

back up clockwise very slightly. The Thermostat will now maintain the

room temperature, if necessary, further increasing or decreasing the

thermostat control may be required to 'fine tune' the ideal room

temperature.

Care and Use of your Mini Convector Heater

 Always disconnect the heater from the mains power supply before cleaning.

 Clean outside of the heater with a clean damp cloth. Never clean with harsh

or abrasive cleaners.

 Do not submerge any part of heater in water or any other liquids.

Technical Data

Voltage

Rated power

Model Number :

220-240V AC 50Hz

450 W

HEA1187