Dot-Spot 25104 Operatör El Kitabı - Sayfa 10

Peyzaj Aydınlatması Dot-Spot 25104 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Dot-Spot 25104 12 sayfaları. Mini led garden spotlight 3w

Sayfayı Yazdır

Safety instructions

In order to protect the exposed connection cable when there is a risk of animal damage, it should

be equipped with a Marten protection (mounting accessories) are provided. Luminaires / power

supplies with defective cables must not be operated any further.

High ambient temperatures shorten the service life of the LEDs. To get a long lifetime of the LED,

good heat dissipation must be ensured. Therefore, do not expose the LED spotlight to ambient tem-

peratures> 50 ° C during operation. Do not cover the LED spotlight, ensure that air can circulate

freely.

Installation

Unpack the entire scope of delivery and check the contents for completeness and Integrity. Dispose

of packaging material that is no longer required in accordance with the applicable regulations.

First attach the mounting bracket of the light to the ground spike with an M6 screw and a locking

ring. The mounting bracket can also be attached directly to suitable surfaces without a ground

spike.

Then the LED spotlight can be screwed into the bracket, the plastic washers are placed between

the lamp and bracket, then the bracket is screwed on the left and right with two M6 screws and a

locking ring. Align the lamp accordingly before tightening the screws.

Plug the connection cable of the spot into the corresponding socket of the power supply unit. If

further extension sets are connected, use the corresponding cable distributor and, if necessary, the

extension cable available as a special accessory. Make sure that the union nuts of the connectors

are firmly tightened, this is the only way to guarantee protection against moisture. The connector

system is reverse polarity protected. We recommend burying the connection cables to protect them

from being bitten by animals or laying them in a conduit. The power supply unit should be placed

in a location that is as protected from the weather as possible. Avoid constant moisture and direct

sunlight. Make sure that the power supply unit cannot be flooded, even in heavy rain. The power

supply unit must not be buried. If necessary, use a housing to protect the power supply unit from

the elements.

Maintenance, care

Clean the LED spotlight from time to time with a damp cloth. Do not cover the spots, remove any

leaves covering the LED spot and ensure that heat can dissipate freely from the housing. dot-spot

mini LED garden spotlights 3W are built without potting, so they can be dismantled and repaired.

This is also an important contribution to environmental protection. Even after the warranty period

has expired, the LED spotlight can be repaired in the event of a fault or damage dot-spot offers

attractive flat-rate repair fees.

Disposal

When the end of use is reached, dispose of the spotlight and all accessories in accordance with

the applicable environmental regulations. Electrical waste must not be disposed of together with

household waste. The dot-spot mini LED garden spotlights 3W can be dismantled into individual

parts after use and thus optimally recycled.