DOTWORKZ HD12-CD-HB Kurulum Talimatları Kılavuzu - Sayfa 11

Güvenlik Kamerası DOTWORKZ HD12-CD-HB için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. DOTWORKZ HD12-CD-HB 16 sayfaları.

4. Enclosure Installation

4.1 Install the Mounting Plate or Wall Mounting Bracket on the HD12 Enclosure using four 1/4-20

fasteners and washers.

4.2 Without the camera installed, bring the enclosure up to the mounting location.

Warnings:



The enclosure weighs 32 lbs. [15 kg] without a camera installed. The final mounting of the

enclosure requires a minimum of 2 people to complete in a safe manner. Do not attempt

to complete this step by yourself.



If the manufacturer provided camera mounting plate is not being used for camera

mounting, it may be easier to mount the camera inside the enclosure before bringing the

enclosure up to the mounting surface.

4.3 Secure the enclosure to the mounting surface by tightening the nuts on the concrete anchors,

screwing the enclosure to the pole mount, or by using alternative fasteners that are appropriate

for the installation. Ensure appropriate torque is applied to each fastener. A thread locking

compound is recommended for these connections.

4.4 Install the camera in the enclosure using the manufacturer provided "twist-to-lock" mounting

plate. If the camera manufacturer does not supply a "twist-to-lock" mounting plate, use the 2 x

1/4-20 fasteners that were supplied (see 4.5). This is more easily achieved prior to mounting the

enclosure.

4.5 Establish all video and communication connections to the camera before applying power. Once

all other lines are connected, connect the coaxial power cable from the Dotworkz electronics to

the camera. This cable is included and connected to a 12VDC source.

4.6 Connect line power to the Dotworkz electronics via the supplied terminal that is marked black

(hot), white (neutral) and green (protective ground). This will provide power to the

environmental controls and to the camera.