Electra evolution Kullanıcı Kılavuzu - Sayfa 15
İnterkom sistemi Electra evolution için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electra evolution 19 sayfaları. Kit video door phone 2 families
Sayfayı Yazdır
During the call and/or
communication, the
image on the
Terminal's screen
7
presents horizontal or
oblique lines, fixed or
mobile (moar)
At a repeated
monitoring
command on any
video Terminal
8
installed, the image
disappears (black LCD
screen)
The system functions
9
(Supply control unit
with accumulator)
The system functions
10
(Supply control unit
with accumulator)
The system functions
(Supply control unit
11
with accumulator)
7
USE
7.1 User safety instructions
Do not hit the glass screen with hard objects!
If the front glass screen cracks, DO NOT touch the product!
Control unit:
S1: green
S2: green
PROG:
Control unit:
S1: green
S2: green
PROG:
Control unit:
S1: intermittent red
– green
S2: green
PROG:
Control unit:
S1: intermittent red –
green
S2: green
PROG:
acoustic signal
Control unit:
S1: red
S2:
PROG:
The wires connected
to the Vin / Vout and
GNV terminals are not
twisted until close to
the terminals (until
approx. 1 cm from the
terminals).
The JP1 jumper on the
Supply control unit is
NOT
CONNECTED, at each
stroke of the
MONITORING key
the image on the
screen of the Terminal
will change from the
image sent by the
video Outdoor panel to
off screen (there is no
video signal
connected to the Vin2
input of the Supply
control unit)
The accumulator is
in charging mode
Defect accumulator
or discharged
Lack of tension from
the 230V AC network
The system
functions powered
by the accumulator
Locate and remedy the
defect.
Connect the JP1 jumper.
,
Check that at a repeated
monitoring command, the
image on the Terminal's
screen remains unchanged.
ok
Replace the
accumulator
Check the 10A fuses from
the electrical panel and the
1,6A Fuse 1 from the Supply
control unit input.
Check the continuity of the
supply cables.
EN
15