DoubleSight DS-27PS Hızlı Kurulum Kılavuzu - Sayfa 8

Raflar ve Standlar DoubleSight DS-27PS için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. DoubleSight DS-27PS 12 sayfaları. Full motion single monitor arm, pole mount

Sayfayı Yazdır

INSTALLATION

Installing your Monitor

Note:

Using of improper screws size may damage your display. If spacers are required, be sure to use correct size of

screws. Proper screws used will easily and completely thread into the display mounting holes. Inadequate thread

engagement in the display may cause display falling.

Note:

It is installer's responsibility to make sure the combined weight of all components does not exceed weight capacity.

Exceeding weight capacities can result in severe personal injury or damage to equipment.

Attaching the Monitor to the VESA Bracket

1. Ensure VESA Bracket on the LCD Arm (1) is able to swivel and tilt easily. (See Figure 8)

Figure 8

2. Carefully place your monitor face down on a smooth level surface being careful not to scratch the surface of the

Monitor. You should have already removed any factory installed stand or base.

3. Locate the 4 VESA Screw Holes on the back of your monitor. Place the LCD Arm over the VESA Holes aligning the

Bracket Holes with the Monitor Holes. Using the monitor screws provided attach the Arm to the Monitor. Use caution not to

over tighten, stop immediately if you encounter resistance. (See Figure 9)

Figure 9

Model: DS-27PS