Doug Fleenor Design NODE2 Manuel - Sayfa 2

Kayıt Ekipmanları Doug Fleenor Design NODE2 için çevrimiçi göz atın veya pdf Manuel indirin. Doug Fleenor Design NODE2 10 sayfaları. Two port ethernet to dmx512 interface

Sayfayı Yazdır

Product description

2 is an Ethernet to DMX512 bridging device. It accepts Streaming ACN (ANSI E1.31),

ODE

Artistic License's Art-Net and other protocols including draft sACN, KiNeT (ColorKinetics) and

ShowNet (Strand Lighting). There are two fully isolated DMX512 ports. N

with two inputs, one input and one output, or two outputs.

Each DMX512 port has a two-digit LED display and up/down buttons to select the universe

number for the associated port. The decimal point LED on each display is the DMX512 signal

present indicator.

History. N

2 was developed for a large hotel's ballroom and conference center. The events

ODE

department wanted a DMX512 distribution system that would allow them to plug a console into

any of the venue's input wall plates, and route that signal to any of the output wall plates. They

specified the Doug Fleenor Design Router-Router, however they needed 20 inputs and Rotor-

Router maxed out at 12. Doug Fleenor Design worked with the hotel planners to meet their

any-input-to-any-output goal; N

one input and one output. The input number is fixed, and the output number is selectable.

Event staff plug the console into any N

2, the staff sets the output to that number to access that DMX512 signal.

ODE

The factory default configuration covers most applications. The front panel allows DMX512

universe selection for sACN (E1.31). An internal web interface (accessed with a computer and

web browser) is used for additional configuration changes.

2 is powered by PoE (Power over Ethernet). It fits in a North American two-gang wall box

ODE

with a minimum depth of 2.125 inches.

Environmental

Operating temperature: 0-40º C (32-104° F)

Operating humidity: 10-90% non-condensing

Indoor use only.

Electrical requirements

Power Over Ethernet (PoE), 802.3af. 3 Watts.

Cabling

A single Category 5 (or higher) cable carries power and data for N

45 jack on the rear of the unit. An Ethernet switch which supplies PoE, or a PoE injector, is

required. Standard Ethernet installation practices must be observed (like 100 meter maximum

cable length).

2 is the result. In this hotel's application each N

ODE

2 and note the input (universe) number. At any other

ODE

Page 2 of 10

2 may be ordered

ODE

2 has

ODE

2 through a standard RJ-

ODE