Doug Fleenor Design 123 Kullanıcı El Kitabı - Sayfa 2

Amplifikatör Doug Fleenor Design 123 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Doug Fleenor Design 123 5 sayfaları. Dmx512 isolated splitter/amplifier

Sayfayı Yazdır

The Splitter/Amplifier provides between one and eleven DMX512 outputs from a single

DMX512 input. The outputs are electrically isolated from the input and from each other

by 2500 volt optical couplers.

All models of our Splitter/Amplifier boost the signal as well as isolate it. Input levels as

low as 0.2 volts are transmitted at full EIA-485 levels (about 4.5 volts).

The splitters allow the DMX signal to be split without the possibility of reflections from one

signal path interfering with the signal to a device on a different path. By isolating each

output, electrical noise and hazardous voltages on one output are prevented from

affecting (or damaging) devices on the input or another output.

Common uses for the Splitter/Amplifier include:

Boosting the signal level on long control runs (greater than 500 feet)

Splitting the signal to multiple dimmer locations

Splitting the signal between dimmers and other DMX devices (color changers, moving

lights, etc.)

Isolating two or three dimmer packs from each other.

Although this product was designed for the digital multiplex lighting control standard

DMX512, the units use standard EIA-485 components. They can be used to split and

isolate any single-drop uni-directional EIA-422 or EIA-485 line up to the rated data rate of

250 Kb/s.

Plug the splitter's line cord into a grounded electrical outlet. The splitter requires between

100 and 120 volts, 50 or 60 hertz. It requires less than 1/10 amp (12 Watts). It should

be grounded for maximum electrical noise isolation and safety. The earth ground is

connected only to the chassis. All circuitry is isolated from the chassis and the power

cord's ground pin.

Plug the console or other DMX source into the Splitter/Amplifier's input connector.

Connect the output(s) of the unit to the dimmers or other DMX receivers.

The splitter is normally provided with the connectors specified for DMX512:

Input = 5 pin male "XLR" style

The signals on each pin are:

1 = Common

2 = Data -

3 = Data +

4 = No Connection

5 = No Connection

The unit may also be ordered with non-standard connectors such as 3 pin "XLR" style.

Note that pin 1 is common in name only. All commons are electrically isolated from each

other.

Product Description

Setup and Connections

Output = 5 pin female "XLR" style