Doug Fleenor Design RERUN-A Kullanıcı El Kitabı - Sayfa 12

DJ Ekipmanları Doug Fleenor Design RERUN-A için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Doug Fleenor Design RERUN-A 15 sayfaları. Architectural dmx512 recorder

Sayfayı Yazdır

EDITING SHOW PARAMETERS

Cross fading

Each show can have the cross fade function enabled or disabled. When enabled (the default state), the

show will execute a two second fade from the current levels to the levels at the START POINT of the show

when that show is selected. When cross fading is disabled for a show, the levels will jump immediately

from the current levels to the levels at the START POINT of the show.

To enable or disable cross fading, do the following:

Start playing the show to be edited.

Pause the show at any point.

Press and hold the number 10 [SHOW] button. Hold the number 10 [SHOW] button for about

five seconds. While held, the remaining [SHOW LEDS] will indicate the status of other show

and system parameters. The number 3 [SHOW LED] indicates the status of the cross fade

option for that show. While continuing to hold the number 10 [SHOW] button, press the

number 3 [SHOW] button to toggle the state of the option. When the number 3 [SHOW LED] is

lit, the cross fade option is enabled. Set the cross fading option as desired.

Release the number 10 [SHOW] button.

Press the [PAUSE] button to save the new settings and to resume the show. The next time the

show is selected, it will start using the cross fade option as just recorded.

End of show output

When a show is set to stop running at the END POINT (not looping) the behavior of the Rerun Architectural

can be set up in two different ways. By default, a show stops at its END POINT and the Rerun

Architectural continues to send the last levels of that show until a new show is selected. Each show can

be set up to stop sending DMX512 data entirely at the end of the show. By going off-line, many moving

lights and dimming systems will detect the loss of DMX512 and begin their shut down routines.

To alter the end-of-show behavior, do the following:

Start playing the show to be edited.

Pause the show at any point.

If it is not disabled already, disable looping for the show (Looping section above).

Press and hold the number 10 [SHOW] button. Hold the number 10 [SHOW] button for about five

seconds. While held, the remaining [SHOW LEDS] will indicate the status of other show and

system parameters. The number 2 [SHOW LED] indicates the status of the end-of-show output

option for that show. While continuing to hold the number 10 [SHOW] button, press the number

2 [SHOW] button to toggle the state of the option. When the number 2 [SHOW LED] is lit, the

Rerun Architectural will stop DMX512 output at the end of the show. When the number 2 [SHOW

LED] is off, the Rerun Architectural will continue sending DMX512 at the end of the show. Set the

end-of-show transmission option as desired.

Release the number 10 [SHOW] button.

Press the [PAUSE] button to save the new settings and to resume the show.

Note:

The end-of-show behavior will only apply if the show has looping disabled.

If the pile-on feature is enabled, the DMX512 output will remain active if there is an input signal present. In this case,

the output will remain active even if the completed show is set to disable the DMX512 output.

(CONTINUED)

Page 12 of 14