Doughpro DP2350BZ Kullanım Kılavuzu - Sayfa 7

Elektrikli Alet Doughpro DP2350BZ için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Doughpro DP2350BZ 14 sayfaları. Automatic dough press

Sayfayı Yazdır

Symptom

If setpoint is reached but slighty off

in temperature.

Press does not close when pressing

the two, green, start buttons

Heater Platen overheating

Both Upper and Lower Platen not

aligned when activating. You may

experience a shifting of the platens

when coming into contact, or

striking noise.

DP23 0 Automatic Air Press Trouble Shooting Guide

Probable Cause

Offset may need to be calibrated and

adjusted.

Did not simultaneously press the start

buttons exactly at the same time

The Lower Platen switch mounted on

the base is not in contact to complete

circuit

If the Relay (depending the year of

the model) on the coil side are

receiving 12vdc indicates the

Controller is functioning properly. On

the switching side of the relay, is

there 120 vac going to the heater in

question . If there is no voltage on

the to the switching side of the relay

to the heaters, the Relay is not

working properly

Upper and Lower Platen misaligned. On the left side of the Post Collar

DOUGHPRO

Must call (800) 624-6717 ext. 129

for confidential instructions.

Try pressing both buttons eactly at

the same time. This is a anti-tie-

down safety feature.

Make sure the roller plunger comes

into contact (clicking noise). This is

also a safety feature that both

platens are aligned before

Replace Relay If the Controller's

heat-on LED is not lit indicating the

controller is working properly.

(#35) are back- to-back set screws.

Remove the first locking set screw.

Adjust stopping set screw to align

platen (*IMPORTANT* must reduce

air pressure to a minimum as not to

damaging closing platens). After

alignment is complete, re-install

locking set screw as not to move the

alignment set screw.

Action to be Taken

Ref. #'s on

Explosion

Drawing

___