Douglas 64800 Manuel

Aksesuarlar Douglas 64800 için çevrimiçi göz atın veya pdf Manuel indirin. Douglas 64800 2 sayfaları. Fence mount rebounder

Sayfayı Yazdır

Douglas

Fence Mount Rebounder

PARTS LIST

Ref# Qty

Description

TUBING

(8)

60"

(4)

12" Braces

(4)

Elbows

FITTINGS

(4)

10-7 Kee Klamp

(4)

Anchor Plates

OTHERS

(1)

Rebound Net

(28)

Bungee Cords

(1)

Webbing Strap

(8)

Set Screws

(1)

Set Screw Key

(4)

U-Bolts

(12)

Hex Bolts

(12)

Nylon Hex Nuts

1. Lay out the main rectangular frame on the ground, do not

assemble the pieces.

2. On the top and bottom of the frame, slide on (2) 10-7

kee-klamps (part 1). Do not tighten these pieces down, allow

them to oat freely.

3. Measure the distance between your fence posts, this will be the

location of the kee-klamps.

4. Assemble main rectangular frame at on the ground by sliding

the eight 60" tubes (part A) together with the four elbows (part

c). Position the kee-klamps based on your fence post

dimension. Do not tighten the kee-klamps.

5. Insert (12) Hex head bolts in the holes. Do not tighten the bolts

until all of the bolts are in installed. Once the frame is one piece,

tighten the hex bolts. Allow the kee-klamps to remain free.

6. Locate the anchor plates on the fence post with approximately

74" between the (2) plates. Using the U-bolts mount the top (2)

plates with the tube facing upwards and the bottom (2) plates

facing down.

7. Insert 12" spacer tubes in all (4) anchor plates and tighten the

set screws on all (4) plates.

8. Lean the main rectangular frame against the fence in

an upright positon.

9. With a ladder at each fence post, slowly raise the frame up to

the top mounting brackets, inserting the kee-klamp on to each

spacer tube.

10. Make sure the tube is set all of the way into the bottom of the

kee-klamp.

11. Repeat the procedure on the bottom anchor plates, there

should be enough ex in the frame to locate the kee-klamps.

12. Measure from the kee-klamps to the outside edge of the frame

in both directions, making sure that the dimensions are the

same.

13. Tighten all bolts on the frame, kee-klamps, spacer tubes and

mounting brackets.

14. Install net with (9) bungees across the top and (9) across the

bottom evenly spaced and (5) on each side.

Note: Start with one in each corner.

15. Install white webbing 36" from the ground, weave webbing

through the net.

Item # 64800