Douglas GCW-1 Kullanım Kılavuzu - Sayfa 16

Endüstriyel Ekipmanlar Douglas GCW-1 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Douglas GCW-1 18 sayfaları. Water washing machine

Before starting the programming, make sure the 120 volt service is turned on and there is no water in the

wash tank. With the control voltage turned on, the colon on the touch pad display will be illuminated and

flashing.

To initiate programming, depress the stop button, then depress the power button by holding both buttons

at the same time until you hear a beep and see four 0's (0.00:0) on the display. At this point the machine will

automatically fill with water until the level reaches the probe. After this, you may begin the programming.

The programming for the fill of the wash tank will be first, and could be the only function you need to pro-

gram. All other functions have been factory preset.

Initiate Auto Fill by depressing the long cycle button. The fill process will start and the display timing will

begin. After the water level has reached overflow, depress the medium cycle button. This will stop the flow

of water and display timer. Next, depress the short button to enter the programmed time into the PC Board.

After programming the wash tank fill, depress the short button to scroll through the remaining functions

either to exit the program mode or make any changes to the following functions. In order to exit the program

mode, you may scroll through the remaining functions or depress the stop button for two seconds.

1. Auto Fill Time

2. Heater Delay (preset at 15 seconds)

3. Short Wash Cycle Time (preset at 4 minutes)

4. Medium Wash Cycle Time (preset at 6 minutes)

5. Long Wash Cycle Time (preset at 8 minutes)

6. Rinse Time (preset at 30 seconds)

7. Dwell and Fan Time (preset at 1 minute)

The settings on these functions can be changed while viewing the preset times. Depressing the medium

cycle button will decrease the time. Depressing the long cycle button will increase the time. After any change

has been made, you must depress the short button to enter the change.

If an error code is present on the display, you must identify the error, resolve the problem and clear the error

code from the PC Board. To clear error codes from the touch pad display depress the stop button. Error

codes are as follows:

Er01: The machine has exceeded the allowable fill time, indicating low incoming

water pressure

Er02: The stop button has been pressed during the wash cycle

Er03: Excessive water loss during operation

Er04: Control board error, may need reprogramming

Er05: Operation of the machine has been attempted without adequate water in the

wash tank

Er06: Door has not closed properly

Er07: Pump overload device has been tripped

DougMac.com

PROGRAMMING THE TOUCH PAD PC BOARD

GCW-1