Baumer Hubner HMG10 Montaj ve Kullanım Talimatları - Sayfa 21

Medya Dönüştürücü Baumer Hubner HMG10 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları indirin. Baumer Hubner HMG10 40 sayfaları. Incremental encoder with magnetic sensing

Sayfayı Yazdır
5.6
Switching characteristics speed switch (option)
Event
During initialisation
After initialisation and
speed ≤ -ns (off)
-ns (off) < speed ≤ -ns (on)
-ns (on) < speed < +ns (on)
+ns (on) ≤ speed < +ns (off)
+ns (off) ≤ speed
High resistance
Resistance between
SP+ and SP-
Low resistance
n
= Speed
+ns (off) = Switch-off speed at shaft rotation in positive rotating direction*
-ns (off) = Switch-off speed at shaft rotation in negative rotating direction*
Switching hysteresis
+ns (on) = Switch-on speed at shaft rotation in positive rotating direction*
-ns (on) = Switch-on speed at shaft rotation in negative rotating direction*
* See
section 7, page
MB258EN - 11196411, 21A1, Baumer_HMG10-Inc_EN_202103_MI_11196411
ELECTRICAL CONNECTION / SWITCHING CHARACTERISTICS SPEED SWITCH (OPTION)
-n
-ns (off)
: 10...100 % (factory setting = 10 % min. 1 Digit)
29�
State of the speed switch output
High resistance (overspeed)
High resistance (overspeed)
State unchanged
Low resistance (no overspeed) after initialisation if
the device is rotating between the switching range
during initialisation�
Low resistance (no overspeed)
State unchanged
Low resistance (no overspeed) after initialisation if
the device is rotating between the switching range
during initialisation�
High resistance (overspeed)
-ns (on)
0
+ns (on)
+ns (off)
+n
21/40