Douglas Dynamics WESTERN MVP PLUS 44595-1 Kurulum Talimatları Kılavuzu - Sayfa 9

Otomobil Aksesuarları Douglas Dynamics WESTERN MVP PLUS 44595-1 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics WESTERN MVP PLUS 44595-1 15 sayfaları. Snowplow

Sayfayı Yazdır

HEADLAMPS

WARNING

Your vehicle must be equipped with snowplow

headlamps and directional lights.

Headlamps, hardware, and instructions are found in

the headlamp box.

1. Install the vehicle wiring according to the

instructions provided.

2. Set the headlamp channel on the lift frame, label

to the front, with the holes aligned.

3. With the correct headlamp on the correct side, set

each headlamp and swivel into place as shown.

4. Secure the headlamps with the correct hardware

for the application as shown below. Inner and

outer posts require different hardware. On LED

headlamps, a rubber washer must be installed

under the slotted holes. Hand tighten.

5. Connect the headlamp wires to the headlamps.

6. Aim the headlamps according to the Snowplow

Headlamp Beam Aiming Instructions

(Lit. No. 27769). Tighten LED headlamp fasteners

to 22 ft‑lb (30 N·m). Tighten halogen headlamp

fasteners to 50 ft‑lb (68 N·m).

Halogen Headlamps

Lit. No. 43174, Rev. 04

INSTALLATION INSTRUCTIONS

Headlamp

Swivel

Headlamp

Channel

Lift Frame

1/2" Lock

Washers

1/2" Hex Nuts

From inside the headlamp channel, insert the

cable tie anchors into the holes as shown. The

anchor locking tabs should be horizontal.

Grommet

Cable

Ties

8. For halogen headlamps only, install a split rubber

grommet on each headlamp wire 3" from the

headlamp. Insert the grommet and wire into the

slot on the rear of the channel.

9. Route the wires under the channel and down the

back of the driver‑side vertical support. Secure the

wires to the anchors and the vertical support with

cable ties.

LED Headlamps

1/2" Flat

Washers

Cable Tie

Anchors

Run harness

underneath

channel

Slotted

Hole

1/2" Rubber

Washer

July 15, 2020