Douglas Dynamics WESTERN MVP PLUS 75310-3 Kurulum Talimatları Kılavuzu - Sayfa 6

Otomobil Aksesuarları Douglas Dynamics WESTERN MVP PLUS 75310-3 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics WESTERN MVP PLUS 75310-3 15 sayfaları. Snowplow

Sayfayı Yazdır

Pivot Bar to Pivot Plates

1. Position the T‑frame and pivot bar between the

pivot plates, aligning the hole at each end of the

pivot bar with the appropriate hole in the pivot

plate as determined by distance "d."

2. On each side, insert 1" x 4‑3/4" clevis pins from

the inside of the pivot bar through the correct pivot

plate holes. Secure the clevis pins with 1" flat

washers and 1/4" x 1‑1/2" cotter pins.

1" Flat

Washer

1/4 x 1-1/2"

Cotter Pin

Pivot Bar

1" x 4-3/4"

Clevis Pin

Lit. No. 43174, Rev. 04

INSTALLATION INSTRUCTIONS

Pivot Plates

STAND SHOE

The stand plunger spring is shipped

compressed and tied. Do not cut the spring

tie until final stand shoe adjustment is

complete and the roll pin is installed.

Initial stand shoe height adjustment is based on

the receiver height measurement (distance "d")

determined in Step 1 under "Pivot Plate Hole Position."

A final adjustment of the stand shoe will be made after

attaching the snowplow to the vehicle.

1. Slide the stand shoe into the stand tube and align

the 1/4" hole in the stand tube with the 1/4" hole in

the stand shoe as determined from the table and

illustration.

Stand Shoe Position

Distance "d"

13.0" – 14.5"

14.5" – 16.0"

16.0" – 17.5"

17.5" – 19.0"

Spring Tie

2. Insert a 1/4" roll pin.

3. Do not cut the spring tie until instructed to do so,

after the final stand shoe adjustment.

WARNING

Position

1/4" Roll Pin

Position 4

Position 3

Position 2

Position 1

July 15, 2020