Douglas Dynamics SnowEx HELIXX 3.5 yd3 Kurulum Talimatları Kılavuzu - Sayfa 5

Serpme Douglas Dynamics SnowEx HELIXX 3.5 yd3 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics SnowEx HELIXX 3.5 yd3 19 sayfaları. Poly hopper spreaders

Sayfayı Yazdır

SAFETY PRECAUTIONS

Improper installation and operation could cause

personal injury and/or equipment and property damage.

Read and understand labels and the Owner's Manual

before installing, operating, or making adjustments.

WARNING

• Driver to keep bystanders minimum of

25 feet away from operating spreader.

• Before working with the spreader, secure all

loose-fitting clothing and unrestrained hair.

• Before operating the spreader, verify that all

safety guards are in place.

• Before servicing the spreader, wait for

auger and spinner to stop.

• Do not climb into or ride on spreader.

WARNING

Overloading could result in an

accident or damage. Do not exceed

GVWR or GAWR ratings as found

on the driver-side vehicle door

cornerpost. See Loading section to determine

maximum volumes of spreading material.

WARNING

Do not install the control for this product in

the deployment path of an air bag. Refer to

vehicle manufacturer's manual for air bag

deployment area(s).

WARNING

Vehicles <10,000 lb GVWR: Obstructing the

visibility from the vehicle's rear camera could

result in serious injury or damage. An auxiliary

camera system shall be installed if the

vehicle's rear camera is removed or blocked.

CAUTION

If rear directional, CHMSL light, or brake

stoplights are obstructed by the spreader, the

lights shall be relocated, or auxiliary directional

or brake stoplights shall be installed.

CAUTION

During the hopper spreader installation

we recommend the addition of an OSHA

compliant Backup Alarm. This alarm is

required for OSHA governed employers.

Lit. No. 74041, Rev. 00

SAFETY

• Do not operate a spreader in need of

maintenance.

• Before operating the spreader, reassemble

any parts or hardware removed for cleaning

or adjusting.

• Before operating the spreader, remove

materials such as cleaning rags, brushes,

and hand tools from the spreader.

• While operating the spreader, use auxiliary

warning lights, except when prohibited by law.

• Tighten all fasteners according to the

Torque Chart. Refer to Torque Chart for the

recommended torque values.

Disconnect electric and/or hydraulic power

and tag out if required before servicing or

performing maintenance.

DO NOT leave unused material in

hopper. Material can freeze or solidify,

causing unit to not work properly.

Empty and clean after each use.

NOTE: Lubricate grease fittings after each use.

Use a good quality multipurpose grease.

PERSONAL SAFETY

• Remove ignition key and put the vehicle in PARK

or in gear to prevent others from starting the

vehicle during installation or service.

• Wear only snug-fitting clothing while working on

your vehicle or spreader.

• Do not wear jewelry or a necktie, and secure long

hair.

• Wear safety goggles to protect your eyes from

battery acid, gasoline, dirt, and dust.

• Avoid touching hot surfaces such as the engine,

radiator, hoses, and exhaust pipes.

• Always have a fire extinguisher rated BC readily

available for flammable liquids and electrical fires.

CAUTION

June 15, 2019