Douglas Dynamics SnowEx HELIXX Series Kurulum Talimatları Kılavuzu - Sayfa 8

Serpme Douglas Dynamics SnowEx HELIXX Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics SnowEx HELIXX Series 19 sayfaları. Poly hopper spreaders

Sayfayı Yazdır

INSTALL HOPPER IN VEHICLE BED

1. Remove the strapping and bolts that secure the

spreader to the pallet.

2. Remove the vehicle tailgate.

CAUTION

Before lifting, verify that the hopper is empty

of material. The lifting device must be able to

support the spreader's weight as shown in

the Spreader Specifications table.

3. Lift the spreader and lower it into the vehicle bed.

Be sure to center the hopper on the vehicle bed

from side to side.

Lift the spreader in one of two ways.

a. Use a forklift equipped with fork extensions to

lift the spreader. Verify that the fork extensions

slide through the fork pockets on the electrical

enclosure and the hopper legs.

Verify that at least two fork pockets (per side)

are used for 1.5 and 2.25 yd³ hoppers, and at

least three fork pockets (per side) are used for

3.5 and 5.0 yd³ hoppers.

Lit. No. 74041, Rev. 00

MOUNTING THE SPREADER

Fork Pockets

(Driver's side shown.)

b. Use slings or chains to lift the spreader by the

four tie‑down loops (two per side) located on

the front and rear hopper legs.

Tie-Down Loops

(two per side)

ATTACH SPINNER DRIVE ASSEMBLY

The spreader is shipped with the spinner drive

assembly attached to the chute supports in the

storage position.

1. Remove the four fasteners that secure the spinner

drive assembly to the chute supports. Discard the

fasteners and blocking (not shown).

NOTE: After removing the fasteners, the spinner

drive assembly will no longer be attached to

the spreader. Use caution to avoid injury and/or

damaging the spinner drive assembly.

Spinner Drive

Assembly

Remove

fasteners

(two per side).

Chute

Supports

June 15, 2019