Baumer PMG10P Montaj ve Kullanım Talimatları - Sayfa 17

Medya Dönüştürücü Baumer PMG10P için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları indirin. Baumer PMG10P 36 sayfaları. Absolute encoder
Ayrıca Baumer PMG10P için: Montaj ve Kullanım Talimatları (32 sayfalar), Montaj ve Kullanım Talimatları (32 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (36 sayfalar)

5.2

SSI interface

5.2.1

Data transfer

Clock

Data

Clock frequency 100 kHz��2 MHz

Monoflop time (t) 20 µs (internal)

n, m Number of bits

For continous clocking, the SSI word is transmitted only once followed by zero

values (no ring register operation)�

5.2.2

Function „RESET"

With the function „RESET" (RESET input) the position value of the SSI signal is set to

0 (factory setting, other values are possible on request)�

» A voltage of 4��30 VDC must be applied to the RESET input for more than 100

ms to set the current position to 0�

The RESET input has no influence on the incremental signals.

The RESET input has no influence on the speed switch.

If a voltage of 4��30 VDC is applied to the RESET input during the initialization

phase after switching on, the delay time of 100 ms does not begin until after the

initialization phase�

5.2.3

Function „Rotating direction"

The function „rotating direction" (DIR input) reverses the rotating direction of the SSI

signal�

» A voltage of 4��30 VDC must be applied to the DIR input for more than 100 ms

to reverse the current rotating direction of the SSI signal� For the duration of

the applied voltage of 4��30 VDC, the rotating direction of the SSI signal is then

reversed�

The DIR input has no influence on the incremental signals.

The DIR input has no influence on the speed switch.

MB245EN - 11171693, 19A3, Baumer_PMG10-SSI_II_EN

Position

Speed

n-1...0 bit m-1...0 bit

msb → lsb msb → lsb

ELECTRICAL CONNECTION / SSI INTERFACE

14/29