Baumer PMG10P Kullanım Kılavuzu - Sayfa 23

Medya Dönüştürücü Baumer PMG10P için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Baumer PMG10P 44 sayfaları. Absolute encoder
Ayrıca Baumer PMG10P için: Montaj ve Kullanım Talimatları (32 sayfalar), Montaj ve Kullanım Talimatları (36 sayfalar), Montaj ve Kullanım Talimatları (32 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (36 sayfalar)

Sayfayı Yazdır
Baumer PMG10P Kullanım Kılavuzu
Baumer Hübner
6.6

LED activity indicator

LED
INC1 (additional incremental
output 1)
INC2 (additional incremental
output 2)
Status
Speed
Tab. 2: LED activity indicator
6.7

Output switching behavior Speed switch (optional)

INFO
Default switching speed is 6000 rpm for HMG10P and PMG10P. HMG10 and PMG10 without
programming interface come with the individually ordered permanent switching speed.
Event
During initialization
After initialization and speed being ≤ -ns (off)
-ns (off) < speed ≤ -ns (on)
-ns (on) < speed ≤ +ns (on)
+ns (on) ≤ speed < +ns (off)
+ns (off) ≤ speed
High resistance
Resistance between
SP+ and SP-
Low resistance
n
+ns (off) = Switch-off speed at shaft rotation in positive rotating direction*
-ns (off) = Switch-off speed at shaft rotation in negative rotating direction*
Switching hysteresis
+ns (on) = Switch-on speed at shaft rotation in positive rotating direction*
-ns (on) = Switch-on speed at shaft rotation in negative rotating direction*
V1 | PMG10 & PMG10P SSI
-n
-ns (off)
-ns (on)
= Speed
: 10...100 % (factory setting = 10 % min. 1 Digit)
red
Undervoltage
n
Overload
n
Excess temperature
n
Undervoltage
n
Overload
n
Excess temperature
n
Internal error
Speed higher than switching
speed (overspeed)
Speed switching output state
High-impedance (overspeed)
High-impedance (overspeed)
Status unchanged
Device rotation within this speed range during
initialization results in status low-impedance
(no overspeed) after initialization
Low impedance (No overspeed)
Status unchanged
Device rotation within this speed range during
initialization results in status low-impedance
(no overspeed) after initialization
High-impedance (overspeed)
0
+ns (on)
Operating Manual
Electrical installation
green
OK
OK
OK
Speed below switching speed
+n
+ns (off)
|
6
23