Douglas Dynamics Mid-Duty IMPACT Kurulum Talimatları Kılavuzu - Sayfa 7
Kar Üfleyici Douglas Dynamics Mid-Duty IMPACT için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics Mid-Duty IMPACT 13 sayfaları. Utv straight blade angle, winch lift snowplow
Sayfayı Yazdır
4. With the angle frame parallel to the ground,
remove the wire-lock clevis pin. Fully lower the
jack stand.
Wire-Lock
Clevis Pin
5. Insert the wire-lock clevis pin in the jack stand
hole that aligns with the hole in the angle frame.
Engage the wire lock.
Jack
Stand
Lit. No. 87015, Rev. 00
INSTALLATION INSTRUCTIONS
Jack
Stand
Wire-Lock
Clevis Pin
INSTALL BLADE GUIDES
1. Secure the driver-side clamp to the outermost
rib on the driver's side of the blade using two
5/16" x 1" cap screws and 5/16" locknuts. Tighten
the fasteners to 18 ft-lb.
Driver's Side
5/16"
Locknuts
2. Remove the nut from the bottom of the blade guide.
Insert the blade guide rod into the hole in the top of
the clamp and secure it with the blade guide nut.
Passenger's Side
5/16" x 1"
Cap Screws
Blade Guide
3. Repeat Steps 1 and 2 for the passenger's side.
7
Blade Guide
Rod
Clamp
(DS)
Blade
Guide
Nut
5/16" x 1"
Cap Screws
Blade Guide
Rod
Clamp
(PS)
5/16"
Locknuts
Nut
May 15, 2021