Baumer PMG10P Kullanım Kılavuzu - Sayfa 27

Medya Dönüştürücü Baumer PMG10P için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Baumer PMG10P 40 sayfaları. Absolute encoder
Ayrıca Baumer PMG10P için: Montaj ve Kullanım Talimatları (32 sayfalar), Montaj ve Kullanım Talimatları (36 sayfalar), Montaj ve Kullanım Talimatları (32 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (40 sayfalar), Kullanım Kılavuzu (36 sayfalar)

Sayfayı Yazdır

Baumer Hübner

6.2.6

Output switching behavior Speed switch (optional)

INFO

Default switching speed is 6000 rpm for HMG10P and PMG10P. HMG10 and PMG10 without

programming interface come with the individually ordered permanent switching speed.

Event

During initialization

After initialization and speed being ≤ -ns (off)

-ns (off) < speed ≤ -ns (on)

-ns (on) < speed ≤ +ns (on)

+ns (on) ≤ speed < +ns (off)

+ns (off) ≤ speed

High resistance

Resistance between

SP+ and SP-

Low resistance

+ns (off) = Switch-off speed at shaft rotation in positive rotating direction*

-ns (off) = Switch-off speed at shaft rotation in negative rotating direction*

Switching hysteresis

+ns (on) = Switch-on speed at shaft rotation in positive rotating direction*

-ns (on) = Switch-on speed at shaft rotation in negative rotating direction*

6.2.7

Connecting the supply cable

NOTICE

Equipment damage due to dust or moisture

Inappropriate cable diameters may entail ingress of dust or moisture. In this case, the protection

class is no longer ensured causing device failure or malfunction.

a) Use only appropriately sized cables to make sure the specified protection class is being en-

sured.

INFO

Connection cables are not included in delivery.

V1 | PMG10 & PMG10P CANopen

-n

-ns (off)

-ns (on)

= Speed

: 10...100 % (factory setting = 10 % min. 1 Digit)

Speed switching output state

High-impedance (overspeed)

Status unchanged

Device rotation within this speed range during

initialization results in status low-impedance

(no overspeed) after initialization

Low impedance (No overspeed)

Status unchanged

Device rotation within this speed range during

initialization results in status low-impedance

(no overspeed) after initialization

High-impedance (overspeed)

+ns (on)

+ns (off)

Operating Manual

Electrical installation