Douglas Dynamics WESTERN ENFORCER 97540 Kurulum Talimatları Kılavuzu - Sayfa 7

Kar Üfleyici Douglas Dynamics WESTERN ENFORCER 97540 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics WESTERN ENFORCER 97540 19 sayfaları. Ultramount 2 snowplow

Sayfayı Yazdır
STAND SHOE
WARNING
The stand plunger spring is shipped
compressed and tied. Do not cut the spring
tie until final stand shoe adjustment is
complete and the roll pin is installed.
Initial stand shoe height adjustment is based on
the receiver height measurement (distance "d")
determined in Step 1 under "Pivot Plate Hole Position."
A final adjustment of the stand shoe will be made after
attaching the snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and align
the 1/4" hole in the stand tube with the 1/4" hole in
the stand shoe as determined from the chart and
illustration below.
Do not cut
spring tie.
Stand Shoe Position Chart
Distance "d"
12.75" – 14.0"
14.0" – 15.25"
15.25" – 16.5"
2. Insert a 1/4" roll pin.
3. Do not cut the spring tie until after the final stand
shoe adjustment.
Lit. No. 74914, Rev. 01
INSTALLATION INSTRUCTIONS
Roll Pin
Position 3
Position 2
Position 1
Position
1
2
3
7
June 1, 2020