Douglas Dynamics Western 26470-2 Kullanım Talimatları Kılavuzu - Sayfa 9

Test Ekipmanları Douglas Dynamics Western 26470-2 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Douglas Dynamics Western 26470-2 14 sayfaları. Isolation module light system

Sayfayı Yazdır
ISOLATION MODULE TEST PROCEDURE – 4-PORT MODULES
ISOLATION MODULE 27781 (GREEN
LABEL) OFF-VEHICLE TEST
Set-Up
Before connecting the Isolation Module Tester to the
Isolation Module, ensure the Isolation Module Tester
switches are in the following positions.
Isolation Module Tester Switch
POWER
PARK LAMPS
HEADLAMPS
PLOW ATTACHED
IGNITION SWITCH
HEADLAMP COMMON
HIGH BEAM #2
DEDICATED DRL BULB SYSTEM
Connection
Connect the Isolation Module to the Isolation Module
Tester as follows:
1. Connect Isolation Module Tester cable 1 to
Isolation Module connector 1.
2. Connect Isolation Module Tester cable 2 to
Isolation Module connector 2.
3. Connect Isolation Module Tester cable 3 to
Isolation Module connector 3.
4. Connect Isolation Module Tester cable 4 to
Isolation Module connector 4.
5. Connect the Isolation Module Tester power cable
to a 12V power source by attaching the red
alligator clip to POSITIVE (+) and the black
alligator clip to NEGATIVE (–).
Test Vehicle Lights
1. Place the Isolation Module Tester POWER switch
in the "ON" position. The green POWER indicator
should light.
Lit. No. 26473, Rev. 03
2. Place the PARK LAMP switch in the "ON" position.
The left and right side tester vehicle LOW BEAM
indicators should light.
3. Place the HEADLAMP switch in the "HIGH"
position. The tester vehicle HIGH BEAM indicators
should light.
Test Snowplow Lights
Position
1. Place the PLOW ATTACHED switch in the "ON"
OFF
position. The green PLOW ATTACHED indicator
OFF
should light and both plow HIGH BEAM indicators
LOW
and the plow PARK LIGHTS indicator should light.
NO
OFF
2. Place the HEADLAMP switch in the "LOW"
NEG (–)
position. The plow LOW BEAM and PARK LIGHTS
indicators should now light.
OFF
OFF
3. Place the IGNITION SWITCH in the "ON" position.
The green IGNITION SWITCH and CONTROL
POWER indicators should light.
4. Press and hold the TURN SIGNAL switch in the
"LEFT" position. The plow left TURN SIGNAL
indicator should light. Release the switch.
5. Press and hold the TURN SIGNAL switch in the
"RIGHT" position. The plow right TURN SIGNAL
lamp should light. Release the switch.
6. Place the HEADLAMP switch in the "LOW"
position. The plow LOW BEAM indicators should
light.
7. Place the DEDICATED DRL BULB SYSTEM
switch in the "ON" position. The plow LOW BEAM
indicators should dim.
8. Return the DEDICATED DRL BULB SYSTEM
switch to the "OFF" position. The plow LOW
BEAM indicators should return to their full
brightness.
The Isolation Module Test is complete. Turn Isolation
Module Tester OFF and disconnect Isolation Module.
Disconnect Isolation Module Tester from power source.
9
November 1, 2007