Douglas Dynamics SweepEx Mega-Broom SMB-720 Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 9
Üfleyici Douglas Dynamics SweepEx Mega-Broom SMB-720 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Douglas Dynamics SweepEx Mega-Broom SMB-720 14 sayfaları. Modular broom
Sayfayı YazdırATTACH BROOM TO FORKLIFT
With the SweepEx
®
broom sitting on the ground, and
the mount facing the lift truck, drive straight and level
into the fork pockets until the tips of the forks are
completely dead-ended into the box end of the broom
mount.
ValuSweep
Broom
®
NOTE: For ValuSweep brooms only – Make sure
that the threaded lock-down knob is threaded all
clear of the lift truck fork.
Drive the forklift forward all the way until the end of the
fork tip rests at the back of the fork pocket.
Gently drop the forks down until the forks rest on the
bottom of the pocket. Once the fork tips are fully into
the pocket, lower the threaded lock-knob assembly
all the way down by turning the knob clockwise in a
tightening manner.
tighten to ensure that the broom will not slip off
the forks while back drag sweeping. (DO NOT
OVERTIGHTEN THE KNOB ASSEMBLY FOR
Do not use an external tool to overtighten the
lock-down knob. The ValuSweep attachment is now
complete and sweeping can begin.
Pro-Broom and Mega-Broom
With the fork tips level and fully engaged into the
fork pockets of the Pro-Broom or fork mount on the
Mega-Broom, the following directions apply:
1. Slightly raise the lift truck forks and tilt back to lift
the bristles off the ground 2". This will keep the
forks in the top of the pocket, and the tips of the
forks dead-ended fully into the end stop angle on
the mount.
2. Now that the weight of the broom is completely
suspended on the fork, attach the chain to the fork
carriage on one end and to the broom on the other
end using the clevis hooks. The chain should be
tightened by hand.
3. Repeat the process on the other side.
Lit. No. 48166, Rev. 00
OPERATION
APPLICATIONS
ValuSweep Broom
The ValuSweep broom has 5 rows of bristles
and works well sweeping inside loading docks,
and small parking lots. Typical applications are:
material spills, shrink wrap debris, broken pallet
scraps, Floor-Dry, standing water, light snow from
overhead doorways, and loading docks.
Pro-Broom
The Pro-Broom broom has 8 rows of bristles and
works well sweeping loading docks, lumber yards,
large parking lots, roadways, warehouse recycling
plants, rubbish/material yards, and trucking terminals.
Typical applications are material spills, broken pallet
scrap, mud, dirt, scrap-metal debris, standing water,
light snow and food debris.
Mega-Broom
The Mega-Broom broom has 11 rows of bristles and
works well sweeping lumber yards, construction
sites, nursery yards, job sites, roadways, parking lots,
recycling, and industrial plants. Typical applications
are: material spills, broken-pallet scraps, mud, sludge,
water, scrap metal, light snow, glass, construction
debris, bricks, tires, steel shavings, banding and small
boulders.
9
October 15, 2014