Douglas Dynamics SweepEx ValuSweep Broom VSB-060 Manuel - Sayfa 2

Üfleyici Douglas Dynamics SweepEx ValuSweep Broom VSB-060 için çevrimiçi göz atın veya pdf Manuel indirin. Douglas Dynamics SweepEx ValuSweep Broom VSB-060 4 sayfaları. 60" dust mop kit, broom
Ayrıca Douglas Dynamics SweepEx ValuSweep Broom VSB-060 için: Kullanım Kılavuzu ve Kurulum Talimatları (14 sayfalar)

Sayfayı Yazdır

DMP-060-1

INSTALLATION INSTRUCTIONS

CAUTION

Read this document before installing the dust

mop kit.

CAUTION

Use standard methods and practices

when attaching and installing accessories,

including proper personal protective safety

equipment.

CAUTION

Be aware of and avoid pinch points when

assembling and operating. Pinch points can

exist around levers and when putting two

parts together (during assembly).

1. Attach the broom bracket to the side of the broom

hood using two 3/8" x 3/4" cap screws and 3/8" lock

washers. Tighten fasteners to 20 ft-lb.

NOTE: Verify the longer part of the broom bracket

is facing downward as shown below.

Broom

Bracket

3/8" x 3/4"

Cap Screw

Lit. No. 11275, Rev. 01

Broom

Hood

3/8" Lock

Washer

2. Attach the dust mop retainer to the end of the

mount arm assembly using two 3/8" x 1" serrated

ﬂ ange cap screws. Verify that the dust mop

retainer is positioned as shown below.

NOTE: Do not tighten the serrated ﬂ ange cap

screws at this time.

Dust Mop

Retainer

3/8" x 1"

Serrated Flange

Cap Screws

3. Pull the dust mop over the frame.

NOTE: Verify that the raised area of the frame is

protruding through the opening in the center of

the dust mop.

4. Insert the cross bar of the frame into the hook

at the end of the mount bar assembly, then slide

the dust mop retainer toward the mop end of the

mount bar.

5. Verify that the ﬁ ngers on the mop retainer capture

the frame cross bar in the slot of the mount bar,

then secure the mop in place by tightening the

fasteners to 30 ft-lb.

Mount Arm

Assembly

February 1, 2019