Asus RT-AC56U Hızlı Başlangıç Kılavuzu - Sayfa 2
Kablosuz Yönlendirici Asus RT-AC56U için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Asus RT-AC56U 3 sayfaları. Dual band 2x2 802.11ac
Ayrıca Asus RT-AC56U için: Kullanıcı Kılavuzu (30 sayfalar), Kullanıcı Kılavuzu (30 sayfalar)
Sayfayı Yazdır
here.
Kong also supports the AC56U: dd-wrt.v24-K3_AC_ARM_STD.bin
•
Flash through the GUI or using the bootloader recovery mode (see below)
•
Reset after flashing; do not 30-30-30
•
Set a password, and then configure the router.
Reset
Do not use 30-30-30 hard reset on any ARM router.
1.
Power off the unit.
2.
Press and hold on to the WPS button.
3.
While holding down the WPS button, power on the unit.
4.
Keep holding the WPS button until the power led starts to blink a few times.
5.
When the power led starts blinking / flashing, release the WPS button.
Recovery Mode Flashing
1.
Reset the router (see above)
2.
Power off the unit.
3.
Press and hold on to the reset button.
4.
While holding down the reset button, power on the unit.
5.
Keep holding the reset button until the power led starts to blink on and off repeatedly (recovery
mode).
6.
Plug the computer running the ASUS recovery tool into a LAN port on the router.
7.
Run the ASUS Recovery software, select the correct firmware, and click the "Upload" button.
8.
The ASUS recovery software should detect the router and start to upload.
•
If it doesn't detect the router, try disabling the firewall, or disable then re-enable the network adapter.
1.
Once flashed and rebooted, set your network adapter settings back to DHCP.
2.
Reset again (see above), and open 192.168.1.1 in the browser.
OEM Firmware Installation
1.
Download the Asus firmware and recovery tool (or use any TFTP utility)
2.
Set a static IP of e.g. 192.168.1.5, subnet 255.255.255.0 (Gateway & DNS blank or 192.168.1.1)
3.
Do a reset and use the Asus recovery mode to flash the OEM firmware.
VLAN Configuration
https://www.dd-wrt.com/phpBB2/viewtopic.php?p=907650#907650
VLAN Configuration
Asus_RT-AC56U
2