Baumer EXG Kullanıcı Kılavuzu - Sayfa 7
Dijital Kamera Baumer EXG için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Baumer EXG 42 sayfaları. Gigabit ethernet
Sayfayı Yazdır
2.1.1.1 Global Shutter
Global shutter means that all pixels of the sensor are reset and afterwards exposed for a
specified interval (t
exposure
For each pixel an adjacent storage area exists. Once the exposure time elapsed, the
information of a pixel is transferred immediately to its storage area and read out from
there.
Due to the fact that photosensitive surface get's "lost" by the implementation of the stor-
age area, the pixels mostly are equipped with microlenses, which focus the light to the
pixels active area.
2.1.1.2 Rolling Shutter
Rolling shutter means that – in contrast to the global shutter – not the whole sensor is
exposed at once, but single portions successively. It is said the shutter "rolls" over the
sensor�
For Baumer EXG cameras with rolling shutter this means two pointers are "rolling" across
the sensor:
▪ First, the reset pointer deletes any information of former exposures stored within the
pixels (Frame
). After that the pixels are empty and restart collecting information
(n-1)
from incoming light – the new exposure (Frame
▪ Once a predefined interval – the exposure time t
pointer rolls across the sensor and the information of the pixels is read out.
▪ For example: On Baumer EXG50, the pass of a pointer lasts approx. 72 msec
(t
).
Full Frame
Notice
Due to technical issues of rolling shutter, a flash control depending on the exposure
time does not make sense. Such cameras should be used in a continuously illuminated
environment.
).
Pixel
Active Area (Photodiode)
Storage Area
Reset Pointer
Readout Pointer
Pixels of Frame
(n-1)
Currently exposed pixels (Frame
Read out pixels of current Frame (Frame
) begins.
(n)
– is elapsed, the readout
exposure
Microlens
◄ Figure 5
Structure of an imaging
sensor with global shut-
ter (interline).
– will be deleted
◄ Figure 6
)
(n)
Operating mode of a
)
rolling shutter.
(n)
7