Amphenol Telaire Ventostat T8100 NS Series Kullanıcı Talimatları
Aksesuarlar Amphenol Telaire Ventostat T8100 NS Series için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Amphenol Telaire Ventostat T8100 NS Series 4 sayfaları. Co2 sensor
Sayfayı Yazdır
Installing the Sensor
Before performing service or maintenance operations on
the systems, turn OFF main power switches to the unit.
Electric shock can cause personal injury. Please read and
follow the wiring instructions precisely; miswiring may
cause permanent damage to the product
Basic Installation for T8100-NS and NSP
1. Separate the case into its front and rear sections.
2. Secure the rear section of the case to the wall or junction box using
the supplied screws, and make necessary wire connections.
3. Mount the Controller on the base by aligning the top clips and then
securing to the bottom clips. Secure the Ventostat with the supplied
set screw. A one-minute stabilization warmup will take place.
Internal Label
Amphenol
Advanced Sensors
®
!WARNING!
.
Telaire Ventostat™ T8100 NS and NSP Series
Amphenol Advanced Sensors
6860 Cortona Dr., Suite B
Goleta, CA 93117
www.amphenol-sensors.com
CO
Sensor
2
User Instructions
T63351-003
September 2014
Page 1 of 4