Amphenol RJS-BKN-MG7F3G-704 Kullanıcı Kılavuzu - Sayfa 9
Ağ Yönlendiricisi Amphenol RJS-BKN-MG7F3G-704 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Amphenol RJS-BKN-MG7F3G-704 15 sayfaları. Ip65/68 sealed managed rugged ethernet switch
Sayfayı YazdırSection 4
Overview
RJ45 Wiring
Guidelines
RJ45 Cable
Distance
Duplex
Operation
Network
Device Check
Managed Switch Hardware Manual
Amphenol
– 948, Promenade de l'Arve – BP 29 – 74311 THYEZ Cedex – France - +33(0)4.50.89.28.00 www.rjswitch.com
Ethernet Wiring
The Managed Switches provides connections to Ethernet devices on the battlefield. Typically the
gigabit port is used to connect to another Ethernet switch or hub that is connected to the main
Ethernet backbone. The other Ethernet ports are then connected to Ethernet devices such as PLCs,
Ethernet I/O, or industrial computers. Electrical isolation is provided on the Ethernet ports for
increased reliability.
Use data-quality (not voice-quality) twisted pair cable rated category 5 (or 5e for gigabit) with
standard RJ45 connectors. For best performance use shielded cable.
Please note that these cables are available as straight-thru or cross-over configurations. Either type
can be used because these switches support auto-MDI/MDIX-crossover.
Most standard Ethernet cordsets follow one of the TIA-568 guideline given hereafter.
The maximum cable length for 10/100/1000BaseT is typically 100 meters (328 ft.).
The RJ45 ports will auto-sense for Full or Half duplex operation, while the fiber ports are
configured for full duplex operation. Note: Fiber devices with half duplex settings should still
communicate with the switch. If otherwise then contact your switch vendor.
The Managed Switches are capable of supporting 10/100BaseT or 10/100/1000BaseT following to
the port. Make sure you connect the appropriate devices to each port.
Page 9 of 14
Last Revised: 25-Jun-13