Amphenol Procom GF 401/s Hızlı Başlangıç Kılavuzu - Sayfa 2

Anten Amphenol Procom GF 401/s için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Amphenol Procom GF 401/s 2 sayfaları. 0 db mobile glassfix antenna for the 450 mhz band

Sayfayı Yazdır
GF 401/...
1. BEFORE INSTALLATION
When selecting mounting location take into consideration: positions of back view mirror,
wiper blade paths and defrosting wires (when mounting on rear window). The driver's
view should not be obstructed.
Max. allowed curvature of the glass surface on the mounting spot is 2 mm deflection per
100 mm length.
Environmental- and car temperature must be above 15° C at installation and surfaces to
be glued must be dry and clean.
2. INSTALLATION
Do not use sealer on rubber gasket or other places.
3. AFTER INSTALLATION
Allow the silicone gluings to dry off 2 hours at a temperature above 15° C. To ensure full
strength of the glue, it is recommended to keep the whip off the mount for 24 hours.
PROCOM A/S reserves the right to
amend specifications without prior notice
4. TUNING INSTRUCTIONS
Insert a forward/reflection-type wattmeter between the transmitter and the antenna.
Key the transmitter and observe the forward and the reflected power.
Adjust the tuning screw on the matching unit until minimum returned power is obtained.
REINSTALLATION KIT
A reinstallation kit including all necessary parts for transfer of the antenna to another vehicle
is available under order No. »GF-RK« (130000329).
WARING
SAFETY PRECAUTIONS
Antennas mounted on the windscreen may cause relatively high field strengths in the
passenger cabin and near the dashboard.
1. To prevent health hazard due to RF radiation, persons must not closer than 30 cm to
the antenna whip (transmitter output power to the matching unit: 20 W). (DIN 57 848).
2. The RF signals at the dashboard may cause interference in electronic equipment
such as broadcast radio, computer automatics, braking systems, electronic ignition,
relays etc. Some cars are more susceptible to disturbances than others. It is the
responsibility of the installer to carry out a thorough check of the proper functioning
under any conditions of such circuits before finishing installation.
The supplied silicone adhesive contains acetic acid and fungicides. Keep out of reach of
children and dispose properly.
ASSEMBLY DETAILS
Page: 2 of 2
Last edited: 2019/06/07