Dover DESTACO Automating Tomorrow P Series Servis Kılavuzu - Sayfa 6

Endüstriyel Ekipmanlar Dover DESTACO Automating Tomorrow P Series için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dover DESTACO Automating Tomorrow P Series 18 sayfaları.

Sayfayı Yazdır

P Series

Service Manual

B. After removal of the cartridge, tap the shaft

in the opposite direction, and remove the

other cartridge in the same manner.

NOTE: You must remove the input shaft prior to removal

of the output shaft.

Fig.4 Removing input shaft.

6. REMOVAL OF OUTPUT SHAFT

A. Removal the large output oil seal as outlined

in the general statements at the front of this

section.

B. Carefully removing the snap ring, from its

groove in the housing, using a snap ring

pliers.

Fig.5 Removing snap ring.

C. Remove the output bearing cartridge

capscrews and gently tap the end of the

output shaft until the cartridge flange is

separated from the housing enough to pry

or pull the cartridge off. If desired tapped

holes may be added to the flange portion of

the cartridge for jacking screws.

D. Once the cartridge is removed, you must

remove the cup portion of the output

bearing that is still in the housing. This is

done by using a hammer and blunt

instrument (such as keystock) and gently

tapping on the backside portion of the cup

which extends above the housing,

alternating from side to side to prevent

binding, until the cup is free of the housing.

E. Now the output shaft can be lifted free of the

housing.

7. For replacement of bearings:

A. Use a wheel puller to remove the cone

portion of bearing from shafts.

B. Removal of bearing cup from cartridge: If

prying is not successful it may require

drilling of push off holes or fabrication of

pulling device.

8. CAMCO recommends that all remaining seals be

removed from the cartridges. To reuse seals is a

false economy since most damage occurs during

disassembly if the seal installation procedures

are not followed.

9. The cam and follower wheel are slip fit on the

shafts but there are several dowel pins, screws or

keys holding these parts. After removing the

capscrews, use an arbor press to remove cams

or follower wheel from shaft using caution not to

damage the parts.